675035
16
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
POWX07582 EN
Copyright © 2017 VARO P a g e | 16 www.varo.com
11.2.5 Changing the saw blade (Fig. 5)
HAZARD!The saw blade may be extremely hot and can cause burns,
immediately after you have stopped sawing. Always led a hot saw blade
cool off. Never clean saw blades with flammable liquids.
This can cause injuries, also when the saw blade is not turning. The
movable saw blade guard must cover the saw blade, whenever you tighten
or release the driveshaft bolt (E1).
Always wear gloves while changing the saw blade.
Set the support arm to 0° (vertical) and tighten the bevelling lock nut.
For removing the topmost sawing table, loosen the corresponding screws. Remove the
sawing table.
To prevent that the saw blade rotates, pull the saw blade lock (D1) forward. Use your hand
at the same time to turn the saw blade slowly, until the saw blade latch is activated.
Loosen the driveshaft bolt (E1) of the saw (left-turning thread).
Remove the shaft bolt (E1) and the outer saw flange (E2) from the saw shaft.
Remove the saw blade (18) from the saw shaft and lift it up to remove it from the machine.
Remove the shaft nut (E4) and the inner saw flange (E3) from the saw shaft.
Clean the surfaces of the following components:
The saw shaft
The inner saw flange
The saw blade
The outer saw flange
The shaft nut
The saw blade guard
HAZARD! Do not use any cleaning products (for instance for removing
resin residues) that have the tendency to cause corrosion on light metals;
this could damage the machine.
Fasten the shaft nut (E4) of the inner saw flange (E3) on the saw shaft.
HAZARD! Be sure to fasten the inner saw flange correctly! The saw may
block, or the saw blade may come lose, if the flange is not correctly
fastened. The inner saw flange is correctly mounted when the bevelled
collar (Q1) points to the right and the spring groove points to the left (Fig.
6).
Mount the new saw blade (18) and check the rotating direction (the arrow on the saw
blade must point in the same direction as the arrow on the saw blade guard!).
HAZARD! Only use saw blades that conform to the applicable standards
and that can be used at the maximum speed indicated in the technical data
sheet.
DO NOT use:
Wrong saw blades
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Powerplus POWX07582 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Powerplus POWX07582

Powerplus POWX07582 Bedienungsanleitung - Deutsch - 22 seiten

Powerplus POWX07582 Bedienungsanleitung - Holländisch - 22 seiten

Powerplus POWX07582 Bedienungsanleitung - Französisch - 21 seiten

Powerplus POWX07582 Zusatzinformation - Alle Sprachen - 5 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info