POWX1331LI EN
Copyright © 2017 VARO P a g e | 7 www.varo.com
- Carefully wipe the liquid off using a cloth. Avoid skin contact.
- In case of skin or eye contact, follow the instructions below:
Immediately rinse with water. Neutralize with a mild acid such as lemon
juice or vinegar.
In case of eye contact, rinse abundantly with clean water for at least 10
minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2 Charger
▪ Use the charger provided with the tool only to charge the battery
▪ Never attempt to charge non-rechargeable batteries.
▪ Have defective cords replaced immediately.
▪ Do not expose to water.
▪ Do not open the charger.
▪ Do not probe the charger.
▪ The charger is intended for indoor use only.
8 ASSEMBLY
WARNING: Always check that the power supply corresponds to the voltage
on the rating name plate. Remove the power tool from the packaging. Do
not plug it into the electrical grid before assembly.
8.1 Mounting sanding plate/ saw blade/ spatula (Fig. 1)
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
Take care with sharp tools such as spatulas, saw blades or cutting blades.
▪ Loosen the clamping plate (b) by pulling the quick-release lever (1) completely open.
▪ Hold the opening of the quick-install saw blade, sanding plate or spatula toward the output
spindle which between cover clamp (a) and clamping plate (b), push the accessory in and
place it firmly onto the locating pins (c).
▪ Fasten using the quick-release lever (1) at the lock position as shown in the Fig. 1.
▪ Remove the accessory in the opposite way.
WARNING: This tool is equipped with quick-install accessories during
operating; do not use any unmatched accessories.
WARNING: Check the tight seating of the application tool/accessory.
Incorrect or not securely fastened application tools/accessories can come
loose during operation and pose a hazard.
8.2 Mounting/changing the sand paper
With fast hook and quick release system.
▪ Position the sand paper and press by hand.
▪ Press on the sand paper by giving it a short, firm push against the flat surface of sanding
plate and switch on the power tool.
