POWX1700 EN
Copyright © 2020 VARO P a g e | 7 www.varo.com
7.2.2 To remove:
▪ Depress the latches in the front of the battery pack to release the battery pack and remove
it from the tool.
7.3 Start switch and self-locking switch
▪ When press start switch, push self-locking switch up, which will make the switch in LOCK-
ON.This guarantees the safety for the user and of the tool.
▪ After the pressure enough, pressing the start switch, then the self-locking switch will
sprang back down.
7.4 LED working light
When working, the LED light on the base of the tool is on,
which is good for nightwork.
7.5 Accessories
The supplied accessories perform a variety of functions.
The tapered adaptor can be used on smaller pinch valves to inflate small items like children’s
toys, which usually require the user to inflate them by blowing air into them.
The sport ball needle can be used to inflate any type of sports ball or any other item that
requires an inflation sport ball needle.
NOTE: When inflating items of 10 PSI or less, inflate in short bursts and
check after each burst by feel or with a calibrated measuring device to
determine accurate pressure.
7.5.1 Sport ball needle:
▪ Insert sport ball needle into sports ball valve and inflate.
▪ Remove sport ball needle after inflation.
NOTE: Pressure required for most sports balls is too low for accurate
reading on tool gauge.
7.5.2 Valve adaptor
Before inflating a tire with a valve, loosen the locking nut on the valve stem to inflate. Once
inflation is complete, tighten the locking nut to seal the tire valve.
▪ Loosen the valve locking nut.
▪ Thread the valve adaptor onto the valve stem with the larger open end toward the wheel.
▪ Position the air chuck clamp in the unlock position.
▪ Clamp the end of the air chuck down onto the valve adaptor by pressing air chuck clamp
down until it locks into place.
▪ After inflation, remove air chuck and tighten locking nut.
8 USING THE INFLATOR
▪ Install the battery pack.
▪ Position air chuck clamp in the unlock position perpendicular to the air hose.
▪ Place the air chuck on the valve stem.
▪ Push the air chuck down so that the threaded section of the valve stem is inside the air
chuck.
▪ Clamp the end of the air chuck down onto the valve stem by pressing air chuck clamp
down until it stops or is parallel with the air hose.
