Bedienungsanleitung Powerplus POWX1750 (Seite 7 von 11) (Englisch)

480945

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

POWX1750 EN

 The compressed air produced by the compressor cannot not be used for pharmaceutical,

food or medical purposes except after particular treatments and cannot be used to fill the

air bottles of scuba divers.

6.3 Things you should know

 To avoid overheating of the electric motor, this compressor is designed for intermittent

operation. In the case of overheating, the thermal cutout of the motor trips, automatically

cutting off the power when the temperature is too high. The motor restarts automatically

when normal temperature conditions are restored.

 All the compressors are fitted with a safety valve that is tripped in the case of

malfunctioning of the pressure switch in order to assure machine safety.

 When fitting a tool, the flow of air in output must be switched off.

 When using compressed air, you must know and comply with the safety precautions to be

adopted for each type of application (inflation, pneumatic tools, painting, washing with

water-based detergents only, etc.).

7 ASSEMBLY

7.1 Point to know when setting up the compressor

 Examine the machine for signs of transit damage. Report any damage immediately to the

company which delivered the compressor.

 The compressor should be set up near the working consumer.

 Avoid long air lines and long supply lines (extensions).

 Make sure the intake air is dry and dust-free.

 Do not set up the compressor in damp or wet rooms.

 The compressor may only be used in suitable rooms (with good ventilation and an ambient

temperature from +5°C to +40°C). There must be no dust, acids, vapors, explosive gases

or inflammable gases in the room.

 The compressor is designed to be used in dry rooms. It is prohibited to use the

compressor in areas where work is conducted with sprayed water.

7.2 Fitting the wheels

Fit the supplied wheels as shown in Fig. 3, 4 & 5:

7.3 Fitting the supporting foot

Fit the supplied rubber stopper as shown in Fig. 6.

8 USE

8.1 Voltage

The compressor is equipped with a mains cable with shock-proof plug. This can be connected

to any 230V ~ 50Hz shock-proof socket which is protected by a 16 A fuse. Before you use the

machine, make sure that the mains voltage complies with the specifications on the rating plate.

Long supply cables, extensions, cable reels etc. cause a drop in voltage and can impede

motor start-up. In the case of low temperatures below +5°C, motor start-up is jeopardized as a

result of stiffness.

8.2 Switching ON/OFF

To switch on the equipment set the On/Off push the switch (ref. 8.

Push the On/Off switch (ref. 8) again to switch off the equipment.

8.3 Adjusting the pressure

 You can adjust the pressure on the pressure gauge (ref. 6) using the pressure regulator

(ref. 7).

 The set pressure can be taken from the quicklock coupling (ref. 5).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWX1750 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWX1750

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info