POWXG10220 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
7 SAFETY WARNINGS GASOLINE
WARNING: Use extra care in handling fuels. They are flammable and the
vapours are explosive.
The following points must be observed:
▪ Use only an approved container.
▪ Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refuelling.
▪ Do not smoke.
▪ Never refuel the machine indoors.
▪ Never store the machine or fuel containers inside, where is an open flame, such as a
water heater.
▪ If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
▪ Always replace and securely tighten the fuel cap after refuelling.
▪ If the tank is drained, this should be done outdoors.
8 ASSEMBLY
Note: described actions below may vary slightly depending on model you
purchased.
8.1 Tools for assembly
You will need these tools to assemble your chain saw:
▪ Combination wrench-screwdriver (contained in your user’s kit).
▪ Heavy duty work gloves (user supplied).
8.2 Assembly requirements
Warning: do not start the saw engine until unit is properly prepared.
Your new chain saw will require adjustment of chain, filling the fuel tank with correct fuel mixture
and filling the oil tank with lubricating oil before the unit is ready for operation.
Read the entire user manual before attempting to operate your unit. Pay particular attention to
all safety precautions.
Your user manual is both a reference guide and handbook provided to furnish you with general
information to assemble, operate and maintain your saw.
8.3 Guide bar / saw chain / clutch cover installation
Warning: always wear protective gloves when handling chain.
8.3.1 Mounting the spiked bumper (13)
First, mount the spiked bumper (13) at the front of the cylinder block, using two mounting screws
(included in this package) (spikes must face upwards).
