POWXG50200 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
8 ASSEMBLY
WARNING! To prevent an accidental start that could cause serious personal
injury, always disconnect the engine spark plug HT lead from the spark
plug when assembling parts.
WARNING! Never install, remove or adjust any attachments while power
head is running. Failure to stop the engine can cause serious personal
injury.
▪ Unscrew the locknut (7) from the shaft by turning it clockwise.
▪ Remove the floating disc (6) and washer (5).
▪ Insert the allen key (1) through the hole in the head assembly and into the opening on the
mounting disc (3).
▪ Hold the allen key tight so the mounting disc does not move.
▪ Install the blade (4), washer (5), concave to be upwards and the floating disc (6).
NOTE: The pit side of the washer must be connected with the blade.
▪ Screw down the locknut (7) and tighten it anti-clockwise by holding the allen key.
▪ Remove the Allen key and check for free movement of the blade.
▪ Remove the screw from the cutting head guard.
▪ Insert the left tab into the slot on the cutting head guard.
▪ Align the screw hole in the mounting bracket with the screw hole into the cutting head
guard.
▪ Tighten the screw through the mounting bracket and into the cutting head guard using the
screwdriver provided.
▪ Lay the machine horizontally then fix the bottom of the handlebar bracket with the 2
M5x40 screws attached to the mounting bracket.
▪ Insert the right handle in to the bracket, insert the left handle into the bracket.
NOTE: Ensure the left handle goes in the left side and right handle in the
right side. Do not mix them up.
▪ Install the mounting bracket cover and tighten the 6 screws until the handle is secure.
▪ Connect the latch on the shoulder harness to the strap hangar. Adjust the strap to a
comfortable working position.
9 PRE OPERATION CHECKS
WARNING! This machine is shipped without oil and fuel. You MUST ensure
all fluid levels are correct before operation otherwise you may cause
serious engine damage that will not be covered by the warranty.
WARNING! ALWAYS use a semi-synthetic 4 stroke SAE 10W30 engine oil
and straight unleaded petrol.
DO NOT mix the fuel with the oil.
You MUST check the engine oil level before each use.
