Bedienungsanleitung Powerplus POWXG6460 (Seite 11 von 17) (Englisch)

582106

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

POWXG6460 EN

8.5 Restart prevention

To avoid unintentional start up of the shredder After the power supply has been cut, the

shredder is equipped with a ‘restart prevention system’ and will not start up again by itself

when the power goes back on.

You have to Press “run/forward” to switch the shredder back on.

8.6 Shredder start-up

：

 Slide the collect box into place;

 Close the lock handle of the collect box(move upwards) ( to close the safety switch;

 Connect the power;

 Press the green ON button to switch the shredder on;

 Feed material into the feeding funnel;

 The material is automatically pulled in by the chopping knife.

Caution! Longer material standing out from the machine could lash out

when being pulled in by the chopping knife! Keep a safety distance!

Warning! Always use the pusher (Fig.11) if you try to push the material into

the feeding tunnel. Do not use your hands directly! Keep the pusher well

after use.

 Only insert as much material as will not block up the feeding tunnel.

 Chop garden waste that has been stored for some days and is wilted and damp

alternately with branches.

 This will prevent the chopping knife from getting blocked up.

 Do not fill into the shredder any soft material such as kitchen waste instead of

compositing it.

 Widely branched material with leaves must be completely chopped before any new

material is fed in.

 Take care that the chopped material can freely fall from the discharge chute – danger of

backing up!

 The ventilation slots must not be covered by the waste bag or the chopped material.

 After finishing the job, press the red button to switch the shredder OFF .

8.7 Emptying the collect box.

The level of shredded material debris in the collection box can be checked by looking through

the notches on the upper face of the base frame. Always empty the collection box in good time

to prevent it from overfilling.

To empty it, proceed as follows:

 Switch off the device at the ON/OFF switch.

 Press the safety switch down.

 Release the collection box.

 Take the collection box out at the front.

8.8 Adjusting the counter knife (Fig 13)

Counter knife B can be set from 0 to 0.75 mm away from chopping knife A. This distance

should be kept to achieve effective operation.

Soft materials or wet woody branches may be wrapped around the chopping knife or not cut

off clean, while a worn counter knife may cause the same problem after several operations.

There is an adjusting device on the right side of the lower shell. To adjust the distance, turn

handwheel C clockwise. Half a turn will move the counter knife 0.75 mm closer to the

chopping knife.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXG6460 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXG6460

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info