Bedienungsanleitung Powerplus POWXG6490 (Seite 6 von 11) (Englisch)

582107

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

POWXG6490 EN

 Make sure that the logs are free of nails, steel wire and cables. Such objects can be

hurled into the air or disrupt the log splitter. Log ends must be at a right angle to the

direction of the log’s length. Branches must be completely removed down to the trunk.

 Split logs with the grain; not against. Do not lay the log across the log splitter, and do not

leave it in that position for splitting. It is dangerous, and the log splitter may be damaged.

 Never try to split two logs at the same time. One of them could fly up and injure you.

 If the log moves away from wedge, loosen it and turn the log 90.

 Never try to load the machine while it is in operation. Doing so could cause severe bodily

injury.

 Keep hands away from fissions and cavities that form in the log. They can quickly close

and grind or cut off fingers.

 Never force the machine to operate longer than 5 seconds in an attempt to split extremely

hard logs. Try turning the log 90; if that still does not work, the log is too large or hard.

 Do not place undue strain on the wedge by placing the log on the upper part of the wedge.

This could cause the wedge to break or otherwise damage the machine.

 Never leave the log splitter unsupervised while it is operating. If you must leave the log

splitter, even for just a short while, unplug the machine or otherwise prevent its being

started accidentally.

 The log splitter must never be operated by anyone who is tired or under the influence of

drugs or medicine. For safety reasons, the operator must be able to think clearly at all

times.

 Never accept help from another person to loosen a log that has become stuck.

 Check that the power circuitry has the necessary fuses and that the motor’s amperage,

voltage and frequency data are correct. Also verify that the earthing is correct. Use of

earth fault breakers is recommended.

 To lessen the risk of voltage loss, the power supply cables must be of a sufficient diameter

(min. 1.5 mm

). Cables longer than 10 m must measure at least 2.5 mm

. Check that

cords and contacts are not damaged. Verify that they satisfy the requirements for outdoor

use and that the contact is fully depressed. Do not use extension cords that are longer

than 10 m, as doing so may result in loss of voltage.

 The motor’s casing may only be opened if strictly necessary and only by an authorized

electrician.

 Protect the machine and cables from contact with water.

 Handle extension cords with care. Do not attempt to move the log splitter by pulling on the

cable. Do not yank on the cord to pull it from the wall socket. Keep the cable away from

excessive heat, oil and sharp objects.

 Never leave the log splitter unsupervised with the power switch in the “ON” position. Also

be sure to unplug the log splitter when it is not in use, when it is being serviced or cleaned,

or while tools are being replaced.

 Lighting: The log splitter’s entire work area must be adequately illuminated while the log

splitter is being used, serviced or maintained. The same applies for outdoor use. Never

work in conditions with insufficient lighting (dawn, dusk, night), as it increases the risk of

injury.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXG6490 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXG6490

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info