Bedienungsanleitung Powerplus POWXG9020 (Seite 6 von 13) (Englisch)

480873

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

POWXG9020 EN

 Check especially the insulation of the electric cable should be faultless and without any

cracks. If the electric cable is damaged, an authorized local service centre should replace

it.

WARNING: High pressure jets can be dangerous if subject to misuse. The

jet must not be directed at persons, live electrical equipment or the

appliance itself.

WARNING: Do not use the appliance within range of persons unless they

wear protective clothing.

 Do not direct the jet against yourself or others in order to clean clothes or foot-wear.

 Hold the spray lance firmly with both hands.

 The operator and anyone in the immediate vicinity of the site of cleaning should take

action to protect them from being struck by debris dislodged during operation.

 Wear goggles and protection clothes during operation.

 Disconnect from electrical power supply before carrying out user maintenance.

 To ensure appliance safety, use only original spare parts from the manufacturer or

approved by the manufacturer.

 Do not use the appliance if a supply cord or important parts of appliance are damaged,

e.g. safety device, high pressure hose and trigger gun.

 Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it

immediately. Do not put it in water.

 Tires and tire valves may be damaged by the high-pressure jet and then burst.

 Never use the machine in an environment where there could be a danger of explosion.

 It is not allowed to clean asbestos- containing surfaces with high pressure.

 This high pressure washer must not be used at temperatures below 0°C

WARNING: High pressure hoses, fittings and couplings are important for

the safety of the appliance. Use only hoses, fittings and couplings

recommended by the manufacturer.

WARNING: Inadequate extension cables can be dangerous. Cables on reels

should always be completely unwinded to prevent the cable from

overheating.

 If an extension cable is used, the plug and the socket must be waterproof and comply with

the below-mentioned requirements for length and cable dimensions.

 1.0 mm² max. 12.5 m

 1.5 mm² max. 20 m

 If the electric cable is damaged, it must be replaced by the manufacturer or his service

agent or similarly qualified person in order to avoid a hazard.

6.1 Mains power connection

The following should be observed when connecting the high pressure washer to the electric

installation:

 The electric supply connection shall be made by a qualified electrician and comply with

IEC 60364-1

 It is recommended that the electric supply to this appliance should include either a residual

current device that will interrupt the supply if the leakage current to earth exceeds 30 mA

for 30 ms.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXG9020 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXG9020

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info