Bedienungsanleitung Powerplus POWXQG7540 (Seite 13 von 16) (Englisch)

672630

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

POWXQG7540 EN

 Replace worn or damaged parts for safety. For reasons of safety, do not use the

equipment with worn or damaged parts. Parts are to be replaced and not repaired. Parts

that are not of the same quality can damage the equipment and be dangerous for your

safety.

 If the fuel tank has to be drained, this should be done outdoors and when the engine is

cool.

 Wear strong work gloves when removing and reassembling the blade.

 Check the blade's balance after sharpening.

 Check the self-closing guard and grass-catcher frequently for wear and deterioration.

 Whenever the machine is to be handled, transported or tilted you must:

 wear strong working gloves;

 grasp the machine at the points that offer a safe grip, taking account of the weight and its

distribution.

11.1 Changing / draining the oil.

Remove the oil dipstick, remove the oil with the oil extractor, refill engine with approximately

470ml SAE30 engine oil.

Start the engine and allow it to run briefly. Stop the engine, wait one minute and check the oil

level. Top up if necessary.

11.2 Draining the fuel tank (Fig. 10)

 Unscrew and remove the fuel tank cap and use a proper fuel pump to empty the fuel into a

suitable container

11.3 Spark plug (Fig. 11)

Allow the engine to cool down.

Remove the spark plug using the box spanner supplied, clean the plug with a wire brush. Set

the gap to 0.75 mm ( 0.030") using a feeler gauge.

Refit the spark plug taking care not to overtighten it.

Use only correct type spark plug. For best results, replace the spark plug every 100 hours of

use.

11.4 To clean air filter (Fig. 12)

 Unclip the air filter cover and remove the sponge filter element. (To avoid objects falling

into the air intake, replace the air filter cover).

11.5 Cleaning the mower housing (Fig. 13)

Dirt deposits make the start difficult, affect the quality of the cut and the discharge of the grass.

Dirt and grass residues are easiest to remove immediately after the mowing. To avoid fouling

the floor, the underside must be cleaned on the grass.

 Remove the mulching plug / grass catcher.

 Fit the hose connector to the lawn mower and turn on the water tap.

 Start the lawn mower and switch it off again after about 30 seconds. The rotating blade

bar will throw the water onto the underside of the lawn mower and thus clean it.

 Turn off the water tap and remove the hose connector.

 Clean the top with a cloth (do not use any sharp objects).

11.6 Maintenance schedule

REGULAR SERVICE PERIOD

(4)

Before

Each

Use

First

Month

5 Hrs

Every 3

Months

25 Hrs

Every 6

Months

50 Hrs

Every

Year

100

Hrs

Every

Two

Years

or 250

Hrs

Perform at every indicated

month or operating hour

interval, whichever comes first.

Engine oil

Check

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXQG7540 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXQG7540

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info