Bedienungsanleitung PowerTech Marine Power System (Seite 4 von 7) (Englisch)

685327

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

Depending upon the location of your Marine Power System; either above or below the water

line, some additional components may be required to complete the installation. See the following pages

for details on each system.

Cooling Water Supply Through-Hull Seacock Fitting (Flush Hull Type)

Shut OFF Valve

Seawater Strainer

Fuel System Primary Filter / Water Separator

Shut OFF Valve

Exhaust System Siphon Break

Hydro-Muffler

Zinc Anode

Shut OFF Valve or Cover

AC/DC Electrical Systems

Ship to Shore Transfer Switch

Remote Gauge Panel

INSPECTION of EQUIPMENT:

Prior to accepting your Marine Power System, check the unit for any shipping damage and be

sure all accessories ordered are present. Check the contents against the packing list and report any loss

or damage to the transportation company.

RIGGING and LIFTING:

Because of the size and weight of the unit, careful planning for rigging and lifting must be

considered. Each unit is equipped with lifting eyes that are designed to carry the full weight of the

generator. These lifting eyes are located on the upper engine section of the unit and allow the unit to be

hoisted horizontally. In some situations the hatchway may not be large enough to accommodate the unit

in the horizontal position. Therefore hoisting the unit in a vertical position will be necessary and

specialized rigging may be needed to accomplish vertical hoisting. Be especially careful that the rigging

does not interfere with or damage components on the unit. Never attach rigging to components or

accessories, remove these parts if necessary and re-attach after the unit is in place. Special rigging work

is best done by competent and experienced personnel working with proper equipment. Avoid short cuts.

GENERATOR LOCATION and MOUNTING:

As previously mentioned the location of the Marine Power System in the vessel is extremely

important. Follow the vessel manufacturer recommendations should they apply to your installation. All

key factors must be considered when choosing the mounting location for the unit. The engine and

generator end are mounted to a heavy gauge sheet metal base pan by 4 flexible isolators that help

prevent the transfer of vibrations from the generator to the mounting location. The unit must be

orientated on a level and structurally sound mounting platform, and securely bolted into place. Once the

unit mounting is completed the installer may begin attaching the component systems.

VENTILATION:

Most vessels are equipped with an ambient air ventilation system. If your vessel is not equipped

or insufficiently equipped to support the extra demand of a Marine Power System, provisions must be

made to install or increase the volume of ambient air into the area while providing for expulsion of hot

air and hazardous fumes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

PowerTech Marine Power System Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info