685364
20
Zoom out
Zoom in
Vorherige Seite
1/42
Nächste Seite
FINISHING THE INSTALLATION
CHECK LIST
Unit is securely mounted to vehicle
All fasteners are torque to specification
Fuel lines are properly secured
Battery cables are properly secured
Power cable is properly secured
Cables and fuel lines are away from moving components
Cables and fuel lines are away from exhaust
Fuel lines are double clamped and all clamps are tight
All AC power connections are complete and tight
Driver control panel installation is complete
Power outlet box installation is complete
Battery Charger installation is complete
Heating and Air conditioner installation is complete (optional)
FIRST TIME START UP
Before starting the PT-3000:
Check oil level in the Engine
Check coolant level
Make sure all electrical connections are complete
Make sure fuel lines are connected and contain no kinks
Make sure driver control panel Start/Stop switch is in OFF position
Make sure the main power switch in the control panel on the APU is in OFF position
Connect the positive battery cable from the APU to the truck battery
Purge all air from fuel system (See Below)
Check that Air Conditioner / Heater and all AC loads are Turned OFF.
IMPORTANT: Purging Air from Fuel System
Before starting the PT-3000 for the first time it is important to purge the fuel
system of all air trapped in the fuel lines. To do this disconnect the Positive + terminal of
the electric fuel pump from the wiring harness and jumper it to a +12V DC source
(Positive + Battery post on starter). The pump will begin pumping fuel and force any
trapped air out through the return line. Continue pumping fuel through the system for 1
minute. Disconnect the jumper wire and reconnect the Positive + terminal of the fuel
pump to the wiring harness. The PT-3000 is now ready to start.
Turn the main power switch located on the control panel inside the APU to the
ON position. Inside the truck, turn the driver’s control switch to the ON position. The
APU will begin the pre-heat and engine cranking cycle.
WARNING: Be careful of moving parts!!!
17
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für PowerTech PT-3000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info