Bedienungsanleitung PowerTech PTRV- 3 RR (Seite 34 von 44) (Englisch)

685358

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

GENERATOR COMPARTMENT INSTALLATION

In planning the size of the generator compartment or bay, allow for the minimum clearance

necessary to adequately cool the generator set. The thickness of insulation and sound deadening material

used to line the compartment must be taken into consideration when planning this clearance. The

generator set must be securely fastened to avoid unwanted movement from vibration and road shock.

Be sure to use all mounting holes in the base pan to secure the unit to the vehicle support structure.

When designing the compartment allow sufficient room for routine maintenance of the unit and easy

removal when major service is required. Also keep in mind that the compartment must include air intake

opening having a free area equal to or greater than that specified under the “Air Requirements” section

of this manual. Make sure that the compartment is vapor tight and completely sealed off from the inside

of the vehicle to prevent exhaust or other vapors from entering the vehicle. To avoid road splash and the

possibility of igniting combustible materials beneath the coach, enclose all unnecessary free space

beneath the generator compartment.

Line the compartment with a good sound deadening material. The material selected must be

fireproof or highly fire resistant. A 3-layer type foam insulating material is very efficient for absorbing

sound. This type of material is easily cut to size and can be quickly installed using special fire resistant

adhesive which bonds the material to most clean dry surfaces. Other materials such as fiberglass

insulation with heat barrier may also be used.

COMPARTMENT FRAMING

The generator must be bolted to a metal frame, which is either bolted or welded to the frame of

the vehicle. This frame must be designed to withstand a minimum force of 5Gs in any direction. The

frame must support the entire base plate around the outer perimeter and center section. Additional

framing may be required if excessive vibration occurs.

AIR REQUIREMENTS

Each engine is equipped with a high water temperature shutdown switch, which will

automatically shut down the unit if the operating temperature exceeds the limit. To prevent the generator

set from shutting down make sure the compartment openings are large enough to allow adequate

circulation of cooling air. The minimum free air opening in the compartment is 44 sq. in. Remember that

louvers, screens and protective grills will restrict airflow. A relatively open mesh screen will restrict

airflow as much as 45%. The intake opening must be increased to compensate for such restrictions.

NOTE: These minimum clearances between the generator enclosure and the compartment walls will

assure adequate cool air circulation.

1” -------- Service Door

1” -------- Right Side

1” -------- Top

1” -------- Rear

2 ¼” ----- Left Side

NOTE: Ambient temperature is defined as the generators normal operating temperature within its

mounting area. In an RV application this area is referred to as a compartment or bay.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

PowerTech PTRV- 3 RR Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info