Bedienungsanleitung PowerTech PTRV- 8 KSI (Seite 46 von 51) (Englisch)

685359

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

EXHAUST SYSTEM

Exhaust system components will vary from one installation to another; therefore a muffler and tailpipe

may not always be furnished with the Genset. However, it is imperative to install a muffler and tailpipe

to reduce exhaust noise and direct exhaust gases beyond the vehicles perimeter and away from the

normal head-on air stream. Install a tail pipe with as few bends as possible to prevent excessive

backpressure. A properly installed exhaust system must be vapor tight, quiet and completely safe for the

vehicle, its occupants and surroundings. Installation of an approved Spark Arrestor is required.

IMPORTANT SAFETY TIPS:

When exhaust system components are not furnished by Power Technology as part of the Genset, the

installer is responsible for meeting the following requirements.

1) Only use exhaust system components, which do not restrict exhaust flow. A restricted exhaust

system will create excessive backpressure and may cause poor engine performance and possible

engine damage. The maximum allowable backpressure for the engine listed in this manual is

3.012in Hg, (76.5mmHg).

2) Muffler shall be fabricated of aluminized steel or other corrosion resistant material and be of a

welded or crimp construction. A USDA Forest Service approved spark arrestor must be part of the

integral design of the muffler or provided as a separate add-on item.

3) Maintain a minimum of 3 inches (76mm) between the exhaust system components and any

surrounding combustible materials. If the minimum clearance cannot be maintained, an insulating

shield must be installed to prevent the combustible material from exceeding temperatures of 117°F

(65°C) above ambient temperature.

4) Extend the exhaust system a minimum of 1 inch (25mm) beyond the vehicles perimeter. Never

terminate the exhaust system underneath the vehicle.

5) Terminate the exhaust system in a direction, which prevents the exhaust gases from being drawn

back into the generator compartment and re-circulated.

6) If the exhaust system in located in an area which may become susceptible to road damage from

curbs, speed bumps, or other road obstacles a protective device such as a skid bar or plate should be

installed.

7) To prevent excessive movement and vibration of the exhaust system, install hangers and clamps

designed for use in exhaust systems.

8) Never join or tee the generator exhaust system and the vehicle exhaust system together. Doing so

may cause excessive back pressure on the generator engine, also condensation from one engine can

damage the other engine.

WARNING: LETHAL EXHAUST GAS!

When installing the exhaust system position the tail pipe end

so that discharged exhaust gases are not drawn into the vehicle interior through windows, doors, air

conditioners, etc. During operation an engine discharges deadly carbon monoxide with its exhaust.

Carbon monoxide is particularly dangerous since it is odorless, tasteless, and non-irritating. It can cause

death if inhaled for even a short period of time. Be especially careful if operating the generator set when

parked under calm, windless conditions. Gases may accumulate in these conditions. Park your vehicle so

that the exhaust discharges downwind. Always be aware of others in your vicinity. Make sure that your

exhaust discharges away from other vehicles and buildings.

CAUTION: Make sure the exhaust system components are positioned well away from drain openings

beneath the generator set. Also, be sure not to block access to the oil drain plug.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

PowerTech PTRV- 8 KSI Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info