Bedienungsanleitung PowerTech PTS-15T-3 (Seite 29 von 84) (Englisch)

685356

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

INSTALLATION

REQUIREMENTS & RECCOMENDATIONS

Installation requirements may vary with each application depending on generator

specification and optional equipment. Listed below are general recommendations for installing a

Power Technology Stand-By Generator. Only qualified and licensed personnel should be

employed to perform the installation. Follow all Safety Procedures outlined in this manual as

well as those in the optional equipment manuals.

Depending on location, Local and or State Building Codes may apply to

the installation. Be sure to check with the appropriate authorities prior to installation and obtain

the required permits which apply.

NOTE: Damage to the generator and optional equipment due to improper installation may not be

covered by Power Technology Southeast, Inc. Limited Warranty.

LOCATING THE GENERATOR:

A permanent location for the generator is a major factor to consider when planning an

installation. These units are large and extremely heavy and will require a substantial foundation

like a concrete slab to support its weight. Placing the generator directly on the earth is not

recommended, dirt and debris can be drawn into the generator causing untimely component

failure. Another consideration is water drainage, low lying areas prone to flooding should be

avoided. Therefore planning for a permanent location is an important first step in the installation.

Local and or State Building Codes may mandate dimensions and materials used in a foundation

or slab.

SERVICABILITY:

As with any machine the generator will require periodic maintenance. Be sure the

generator is accessible on all sides. Recommended clearance between the generator and other

objects is at least 2 feet. This clearance is also required for proper ventilation and cooling. Avoid

locating the generator next to an object which may cause an air flow restriction.

EXHAUST ROUTING:

The exhaust from the generator must be safely routed away from all building openings.

Avoid exhausting near windows, doors, air handlers, roof eves and vents. Avoid exhausting into

confined areas with little or no air circulation. Avoid exhausting near neighboring structures as

well. The exhaust system should be routinely inspected and maintained. Local and or State

Building Codes may mandate exhaust routing.

ELECTRICAL CONNECTION:

In most installations the generator is connected to a buildings existing electrical system as

a back-up electrical supply. This means the generator will be wired into the buildings electrical

panel typically through an automatic transfer switch. Wiring and connections must be made by a

licensed electrician in accordance with Local and or State Building Codes.

FUEL STORAGE:

Depending upon the specific application, the type of fuel storage tank and capacity must

be considered. Typically a fuel storage tank which meets UL 142 Specifications is required.

Location and connections may be mandated by Local and or State Building Codes. Consult your

fuel supplier as to fuel maintenance and extended storage requirements. Adding a fuel stabilizer

may be necessary to extend the usable fuel life.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

PowerTech PTS-15T-3 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info