604306
80
Zoom out
Zoom in
Vorherige Seite
1/91
Nächste Seite
Completing the Assembly
19
Completing the Assembly
CAUTION: The location of the On/Off switch is beneath the cutout on the base frame.
Make sure the power switch is in the Off position. Make sure the power cord is
disconnected from its power source.
Connecting the Power Cord
CAUTION: Use the supplied power cord. Do not remove or otherwise bypass the
3-prong plug with an adapter in order to use a nongrounded outlet. Do not plug the EFX
into a power transformer in an attempt to adjust the voltage requirements. Failure to
follow these instructions might damage the unit and will void the Precor Limited
Warranty. If an appropriate cord for your location was not included with your EFX,
please contact your Precor dealer for the proper Precor power cord. For more
information on authorized Precor dealers in your area, please contact Customer
Support at www.Precor.com.
To connect the power cord:
1. Insert the power plug connector into its receptacle at the rear of the unit.
Figure 40: Plug location
2. Plug the other end into a grounded outlet so you can maintain a consistent
power source without overloading any other circuitry. Be sure to use the
appropriate voltage. Refer to Grounding Instructions in the Owner’s Manual.
3. Use the power switch to turn the unit On. Check that the Precor banner
appears on the display. If the display remains blank, recycle the power. If the
display continues to remain blank, check the cable connections.
Leveling the EFX
Make sure the unit is level before allowing anyone to use it.
CAUTION: To eliminate movement, make sure the adjustable feet are in contact with
the floor.
To level the unit:
1. Gently rock the unit. If there is any movement, ask your assistant to tip the
unit to one side while you locate the adjustable feet.
Figure 41: Leveling the EFX
2. Correct the height of each adjustable foot as follows.
If you want to …
Then turn the adjustable feet …
Raise the unit Counterclockwise
Lower the unit Clockwise
Important: Place the unit on a flat surface. Rotating the adjustable feet cannot
compensate for extremely uneven surfaces.
3. When the EFX is level, tighten the lock nut.
4. When you are finished adjusting the EFX, place the unit on the floor and
recheck that it sits evenly on the floor.
80

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Precor EFX 423 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info