Bedienungsanleitung Precor TRM 211 TREADMILL (Seite 73 von 83) (Englisch)

575664

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

Treadmill 211 Assembly Guide 12

Checking the Alignment

Proper belt alignment allows the belt to remain centered and ensures smooth

operation. Realigning the belt takes a few simple adjustments. If you are unsure

about this procedure, call Precor Customer Support. Refer to Obtaining Service.

CAUTION: Special care must be taken when aligning the running belt. Turn Off the

treadmill while adjusting or working near the rear roller. Remove any loose clothing and

tie back your hair. Be very careful to keep your fingers and any other object clear of the

belt and rollers, especially in front of the roller and behind the deck. The treadmill will

not stop immediately if an object becomes caught in the belt or rollers.

To check the alignment:

1. The treadmill has adjustable rear feet. Make sure that the running surface is

level before aligning or adjusting the running belt. For more information, see

Leveling the Treadmill.

2. Connect the power plug to an appropriate dedicated circuit and turn the unit

On.

3. Stand beside the treadmill and press QUICKSTART.

Note: If needed, enter the password. Refer to your owner’s manual. The

running belt starts automatically after a 3-second countdown appears on the

display.

4. Increase the treadmill belt speed until the display shows a speed

of 3 mph (5 kph).

CAUTION: If you hear any chafing or see that the running belt appears to be getting

damaged, stop the running belt immediately by pressing the red STOP button.

Contact Precor Customer Support.

5. Walk around to the rear of the unit and observe the belt for a few minutes.

The belt should run centered along the running bed. If the belt drifts off center,

you will need to make adjustments. Refer to the next section.

Important: If the belt needs alignment, make the adjustments at once. Failure to

align the belt may cause the belt to tear or fray, which is not covered by the Precor

Limited Warranty.

6. To stop the running belt, press the red STOP button.

7. Turn the treadmill Off.

Adjusting the Running Belt

If you are unsure about adjusting the running belt, contact Precor Customer

Support. Refer to Obtaining Service.

CAUTION: For your safety, use the power switch to turn Off the treadmill before

making any adjustments. Do not adjust the running belt when someone is standing

on the unit.

To adjust the running belt:

1. Locate the right belt adjustment bolt in the rear end cap of the treadmill.

Figure 19: Belt adjustment bolt location

2. To determine left and right, stand at the rear of the treadmill and face the

display. Make all belt adjustments on the right rear corner bolt using the 6

mm hex key.

– If the belt is off center to the LEFT, turn the adjusting bolt ¹₄ turn

counterclockwise, which moves the running belt to the right.

– If the belt is off center to the RIGHT, turn the bolt ¹₄ turn clockwise,

which moves the belt to the left.

Important: Do not turn the adjusting bolt more than

¹₄

turn at a time.

Overtightening the bolt can damage the treadmill.

3. Recheck the alignment of the running belt.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Precor TRM 211 TREADMILL Seite 73

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info