MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the
mains supply. The heater may then be cleaned using a damp
cloth with a drop of washing-up liquid to remove any dust or
dirt from the case. Do no use stronger detergents or solvents
as these may damage the paint finish.
Using a dry 1" (25mm) paint-brush, remove any dust from the
grilles.
If the mains lead is damaged, it must be replaced by the
manufacturer or an authorised service centre. If the mains
plug needs to be replaced, proceed as follows:
Connect the brown wire to the
terminal labelled "L".
Connect the blue wire to the
terminal labelled "N".
Connect the green/yellow wire
to the terminal labelled with the
earth symbol or "E".
Make sure that the cord-grip is
positioned correctly (over the
outer sheath of the cable) and it
fully tightened.
To replace the tube:
Disconnect from the mains supply, and wait until the heater
has cooled down.
Using a pozidriv screwdriver, remove the grille.
Push the tube sideways against the spring, and remove.
To insert a new tube, push one end of the tube into the
socket against the spring, and insert the free end into the
opposite socket.
Replace the grille.
Replacement tubes can be obtained from your supplier, or by
telephoning (0845) 459 4816 quoting part number EH0602.
Page 5
