IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.
BEFORE USE
You must inspect the product including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your
supplier immediately.
INSTALLATION
Place the appliance on a firm, flat level surface.
If continuous drainage is to be used, snap
out the circular apeture in the case on the
right hand side below the grille and
connect a drainage hose to the port. Use
a hose with an internal diameter of 12mm
(½"). Make sure that the hose runs
downwards throughout its entire length,
and has no kinks. Otherwise the drainage
will not work.
OPERATION
• Plug the mains lead into a 13 Amp mains socket.
• If connecting via an extension lead, make sure that the lead is rated at 5
Amps, and that it is fully unwound.
• Place the appliance on a firm flat level surface.
• Switch the appliance on at the mains socket. Then press the power
switch to start operation.The appliance will wait for 3 minutes whilst the
refrigerant settles before starting to operate, this is to extend the life of
the compressor.
• If operating at an ambient temperature below 5 °C, the internal heat
exchanger will drop below 0 °C, causing ice to form, and performance will
be reduced.
• Unplug the appliance from the mains when not in use. (Do not
disconnect whilst still operating, press the POWER switch to switch OFF
first)
Page 2
