Page 7
FAULT CODES
F1 Humidity sensor fault.
F2 Temperature sensor fault.
If either of these faults is detected, stop the appliance by pressing the power
button. When it has stopped, switch off at the mains socket and wait 3 minutes.
Switch back on, and restart the appliance. If the fault repeats contact your dealer.
P1 Appliance is defrosting: This happens if the temperature is lower than 10 °C,
and ice begins to form on the internal heat exchanger. The defrost cycle will last
for a few minutes, and then operation will resume.
P2 Bucket fault. Either the bucket is full, or it is misaligned. Empty the bucket and
make sure it is correctly positioned in the appliance.
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill.
At this cost, the appliance will cost £0.07 per hour to run on the "continuous"
setting. If the humidistat is used, the operating costs will be lower.
TECHNICAL SPECIFICATION
Dimensions: 397×297×502 mm
Weight: 13.5 kg
Power supply: 230 V ~ 50 Hz
Power consumption: 600 W
Operating current: 2.6 A
Refrigerant: R134a (1,1,1,2-Tetrafluoroethane)
Refrigerant load: 115 g
Discharge pressure: 1.7 MPa
Suction pressure: 0.7 MPa
Sealing: hermetically sealed
Airflow: 150 m
3
/h
Moisture removal: 20 litres/day
Tank capacity: 3 litres
Sound level: 48 dB(A)
Coverage area: 37-52 m
2
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste, because
it contains refrigerant gas which is subject to control under the Fluorinated
Greenhouse Gases Regulations 2009.
Most local authorities have specific collection system for appliances and disposal
is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your retailer
may take the old appliance for disposal.
