digit LED display on the front panel in degrees Celsius.
Press the SWING button to select louvre oscillation. Press
SWING again to switch off louvre oscillation.
The TIMER can be used to turn the heater off after it has
operated for a set time. The time can be set in half-hour
intervals from ½ hour to 7½ hour, by repeatedly pressing he
TIMER button. The LEDs on the front panel indicate the time
that has been set (add up the times shown next to the
indicators that are illuminated).
Some control functions are avialable by pressing the buttons
on the front panel of the heater.
Press the button to switch the heater on.
Press once for cool air, twice for low heat and three times for
high heat, four times for high heat with louvre oscillation.
Press the button again to switch off.
Do not touch the air output grille when the heater is in
operation, because it will be hot and may cause burns.
Unplug the heater from the mains when not in use.
OPERATING COSTS
At time of going to press, the average cost of electricity is
£0.12 per unit (kilowatt-hour). The amount you are being
charged will be shown on your electricity bill.
At this cost, the EH1464 will cost £0.24 per hour to run with
the thermostat set to its maximum.
If the thermostat is used to regulate the temperature the
operating costs will be lower, depending on the room
temperature.
Page 5
