Bedienungsanleitung President EMPEROR KENJI (Seite 27 von 48) (Deutsch, Englisch, Französisch, Spanisch)

636657

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

4) BASIC OPERATIONS TO BE CARRIED OUT BEFORE USING

YOUR SET FOR THE FIRST TIME (without transmitting and

without using the «push-to-talk» switch on the microphone)

a) Connect the microphone

b) Check the antenna connections

c) Turn the set on by turning the knob VOLUME (1) clockwise.

d) Turn the SQUELCH knob to minimum (anti-clockwise).

e) Adjust the volume to a comfortable level.

f) Go to Channel 20 using the rotary knob on the front panel or UP / DOWN button

on microphone (4).

5) ADJUSTMENT OF SWR (Standing wave ratio)

WARNING: This must be carried out when you use your CB radio for the first time

(and whenever you re-position your antenna). The adjustment must be

carried out in an obstacle-free area.

* Using an external SWR meter (e.g. SWR 1 or SWR 2):

a) To connect the SWR meter :

- Connect the SWR meter between the CB radio and the antenna as close as

possible to the CB (use a maximum of 40 cm cable, type President CA 2C).

b) To adjust the SWR meter:

- Set the CB to channel 20.

- Put the switch on the SWR meter to position CAL ou FWD.

- Press the «push-to-talk» switch on the microphone to transmit.

- Bring the index needle to ▼ by using the calibration key.

- Change the switch to position SWR (reading of the SWR level). The reading on

the V.U. meter should be as near as possible to 1. If this is not the case, re-adjust

your antenna to obtain a reading as close as possible to 1. (An SWR reading

between 1 and 1.8 is acceptable).

- It will be necessary to re-calibrate the SWR meter after each adjustment of the

antenna.

WARNING: In order to avoid any losses and attenuations in cables used for

connection between the radio and its accessories, PRESIDENT recommends

to use a cable with a length inferior to 3m.

Your CB is now ready for use.

B) HOW TO USE YOUR CB

1) ON/OFF - VOLUME

a) To turn the set on, turn the knob (1) clockwise

b) To increase the sound level, turn the same knob further clockwise.

2) ASC (Automatic Squelch Control)/SQUELCH

Suppresses undesirable back-ground noises when there are no communica-

tion. Squelch does not effect neither sound nor transmission power, but allows

a considerable improvement in listening comfort.

a) ASC: Automatic Squelch Control

Worldwide patent, a PRESIDENT exclusivity

No repetitive manual adjustment and a permanent improvement in listening

comfort when this function is active. It can be disconnected by turning the

switch (2) clockwise, in this case the manual squelch control becomes active

again.

b) Turn the squelch knob clockwise to the exact point where all back-ground

noise disappears. This adjustment should be done with precision as, if set to

maximum, (i.e. fully clockwise) only the strongest signals will be received.

3) CHANNEL SELECTOR ROTARY KNOB

Turning this knob allows you to choose a channel (1-40) for transmitting and

receiving.

4) DISPLAY

The display shows the working channel.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

President EMPEROR KENJI Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info