Bedienungsanleitung President Harry III Classic (Seite 34 von 56) (Englisch, Französisch, Spanisch, Polnisch)

636601

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

The BARGRAPH shows the reception level and the output power level.

4) RF GAIN

Adjustment of the sensitivity during reception. For long distance communications

RF GAIN should be set to maximum. You can reduce the RF GAIN in order to avoid

distortion when your correspondent is close by and when he has no RF POWER.

The normal setting of this function is on maximum (fully clockwise).

5) CHANNEL SELECTOR: Rotary Knob

This button allow increasing or decreasing a channel. A «beep» sounds each time

the channel changes if the KEY BP function is activated. See KEY BP function.

6) F ~ KEY BP

F - FREQUENCY BAND SELECTION

(conﬁ guration: E; d; EU; EC; U; PL)

The frequency bands have to be chosen according to the country of use. Don’t use

any other conﬁ guration. Some countries need a user’s licence.

See the conﬁ gurations/ frequency bands table at page 50 to 53.

Proceeding: switch off the transceiver. Keep the key F pressed and switch on again.

and the letter corresponding to the conﬁ guration are blinking.

- In order to change the conﬁ guration, use the channel selector on the front panel.

- When the conﬁ guration is selected, press 1 second on the F key.

and the letter

corresponding to the conﬁ guration are continuously displayed, a beep sounds. At

this point, conﬁ rm the selection by switching off the transceiver and then switching

it on again.

See table page 53.

KEY BP Beep on changing the channel, keys etc... (long press)

Activate the KEY BP function by pressing 1 second the KEY BP key. A beep sounds

and «BP» is displayed. In order to disable the function, press during 1 second the KEY

BP key. «BP» disappears.

7) LOCK

Allows to lock all the keys on the front pannel and the rotary knob. An error beep

sounds when a key is used and the LOCK function is activated. A press on LOCK

activates/deactivates the LOCK function. appears on the display when the

function is activated.

Transmission and reception remain active.

8) SCAN

Channel research: Allows activating the SCAN function (research of the channels) in

an increasing way. «SCN» is displayed. The scanning stops as soon as there is a busy

channel. The scanning automatically starts 3 seconds after the end of the transmission

and no key is activated during 3 s. The scanning starts again in an increasing way

by turning the rotary knob to the right, or in a decreasing way by turning the rotary

knob to the left.

A new press on SCAN disables the SCAN function.

9) ROGER

The icon « » appears on the display when the function is active. The Roger Beep

sounds when the PTT switch of the microphone is released in order to let your cor-

respondent speak. Historically as CB is a «simplex» communication mode, it is not

possible to speak and to listen at the same time (as it is the case with a telephone).

Once someone had ﬁ nished talking, he said “Roger” in order to prevent his cor-

respondent that it was his turn to talk. The word “Roger” has been replaced by a

signiﬁ cant beep. There comes “Roger beep” from.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

President Harry III Classic Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info