12
CHECK BATTERY CAPACITY
1. Turn on the booster MPB-12000, slide ON/OFF (7) to “ON”.
2. Press POWER (5) without any devices connected to the charger.
3. The number of bars in the battery icon on the display (1) indicate how much power is in the MPB-12000.
4. Turn off the booster MPB-12000, slide ON/OFF (7) to “OFF”.
JUMP START A VEHICLE
1. Make sure the booster MPB-12000 is fully charged.
2. Turn off all accessories on the vehicle (radio, air conditioner, etc.)
3. Connect the jumper cable’s RED clamp to the POSITIVE (+) post of the vehicle battery.
4. Connect the jumper cable’s BLACK clamp to the NEGATIVE (-) post of the vehicle battery.
5. Insert the jumper cable connector into the 12 V connector (8) of the booster MPB-12000. Be sure the
connection is solid.
6. Turn on the booster MPB-12000, slide ON/OFF (7) to “ON”.
7. Turn the vehicle ignition key for 3 seconds maximum.
If the vehicle starts:
• Disconnect the jumper cables from the MPB-12000 rst (8), then disconnect the clamps from the
battery.
If the vehicle does not start:
• Wait 1 minute and try again.
8. Turn off the booster MPB-12000, slide ON/OFF (7) to “OFF”.
CHARGING A 5 V USB DEVICE (TABLET, CELL PHONE, ETC.)
1. Turn on the booster MPB-12000, slide ON/OFF (7) to “ON”.
2. Connect the 2-1 USB cord to the USB output (3) of the booster MPB-12000
3. Connect your device to either the mini USB or micro USB cable.
4. The MPB-12000 begins to charge your device. It will put on standby at the end of the charge.
5. Turn off the booster MPB-12000, slide ON/OFF (7) to “OFF”.
TURN ON FLASHLIGHT
1. Turn on the booster MPB-12000, slide ON/OFF (7) to “ON”.
2. Press and hold POWER (5) to turn on the LED ashlight.
3. Short press POWER (5) again to cycle through the 4 modes: Steady / Strobe S.O.S / Fast Strobe /
OFF.
4. Turn off the booster MPB-12000, slide ON/OFF (7) to “OFF”.
POWER / CHARGE 12, 16 OR 19 V DC DEVICES
1. Turn on the booster MPB-12000, slide ON/OFF (7) to “ON”.
2. Short press POWER (5) to cycle through the 3 DC voltage values: 12 V / 16 V / 19 V. See “OUT2” in
the display (1).
3. Insert the connector cable (not included) into the output jack (4) of the booster MPB-12000 to power /
charge the electronics device.
The voltage value cannot be change while a cable is connected to the output jack (4).
4. When nished, turn off the booster MPB-12000, slide ON/OFF (7) to “OFF”.
COMPACT TIRE INFLATOR
• This is not a toy. Please keep out of reach of children
• Do NOT leave the compressor unattended when in use
• Make sure to stay safe and away from trafc if you have to inate tires at roadside
• Do not use the compressor in explosive atmospheres, in the presence of ammable liquids, gases or
dust
• Do not expose the compressor to rain or wet conditions
• In case of electrical or mechanical malfunction, immediately switch off the compressor and unplug it
• Over-ination may cause items to burst which could cause injury. Do NOT attempt to over-inate.
• The compact tire inator cannot be serviced by the user.
