Bedienungsanleitung Pride Celebrity 2000 (Seite 29 von 34) (Englisch)

721980

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

Celebrity

X. BASIC TROUBLESHOOTING

Any electromechanical device requires occasional troubleshooting. However, most problems that arise can usually

be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not

fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FLASH CODES

Diagnostic flash codes help you perform basic troubleshooting quickly and easily. A diagnostic flash code will flash

from the status LED in the event one of the conditions listed below develops. After you perform the solution

associated with the diagnostic flash code, your Celebrity should resume normal operation

NOTE: Your Scooter will not run unless the flash code condition is resolved and the Scooter has been

turned off then turned back on.

What if all the systems on my Celebrity seem to be dead?

n Make certain that the key is in the on position.

n Check that the batteries are fully charged. See V. Batteries and Charging.

n Push in the the main circuit breaker reset button. See IV. Description.

n Make certain that both battery harnesses are connected firmly to the rear electronics module and to the battery

terminals. See VIII. Disassembly and Assembly.

n Make sure the front-to-rear harness is firmly connected to the rear electronics module. See VIII. Disassembly

and Assembly.

n Be sure the auto shutoff feature hasnt been activated. See V. Batteries and Charging.

n Check the fuses. See XI. Care and Maintenance for fuse replacement.

What if the motor runs but my Celebrity does not move?

n With the key turned to the on position, check the status LED. If the LED flashes three times, a pauses shortly,

then flashes two times, this is the manual freewheel lever code meaning your Celebrity is in manual freewheel

mode.

n When the manual freewheel lever is pulled up, the brakes are disengaged and all power to the transaxle is cut.

n Push the manual freewheel lever down to restore your Celebrity to normal operation. See IV. Description.

FLASH CODE CONDITION SOLUTION

Batteries are too low to operate the

Scooter or the charger is operating.

Charge batteries or unplug the charger power

lead from the electrical outlet.

Controller is hot; the Scooter seems to

be losing power.

Shut down your Scooter for a minimum of

several minutes to allow the controller to

cool.

Wigwag fault; your throttle control

levers are not responding.

Contact your authorised Pride provider for

assistance.

The manual freewheel lever is in the

freewheel (up) position.

Turn the Scooter key to the off position, then

push the freewheel lever to the drive (down)

position, restart your Scooter.

Scooter is operating with the charger

attached.

Unplug the charger cord from the charger

power cord receptacle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pride Celebrity 2000 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pride Celebrity 2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info