Bedienungsanleitung Pride Go-Chair (Seite 23 von 32) (Englisch)

668252

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Care and Maintenance

Your Go-Chair is a sophisticated travel mobility vehicle. Like any motorized vehicle, it requires routine

maintenance checks. You can perform some of these checks, but others require assistance from an

authorized Pride Provider. Preventive maintenance is very important. If you follow the maintenance checks in

this section as scheduled, you can help ensure that your Go-Chair gives you years of trouble-free operation.

If you have any doubt as to your Go-Chair’s care or operation, contact an authorized Pride Provider.

WARNING! Do not service the Go-Chair when the seat is occupied.

Your Go-Chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp

areas of any kind.

WARNING! Direct or prolonged exposure to water or dampness could cause

the Go-Chair to malfunction electronically and mechanically. Water can cause

electrical components to corrode and the chair’s frame to rust. Travel chairs

should be examined periodically for signs of corrosion caused by water

exposure, bodily ﬂ uid exposure, or incontinence. Damaged components should

be replaced or treated immediately.

Should your Go-Chair come in contact with water:

1. Dry your Go-Chair as thoroughly as possible with a towel.

2. Allow your Go-Chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.

3. Check the controller operation and the brakes before using your Go-Chair again.

4. If any inconsistencies are found, take your Go-Chair to an authorized Pride Provider. Travel chairs

that are frequently exposed to sources of water, such as incontinence, should be inspected often for

corrosion and electronic components may need to be replaced frequently.

Temperature

 Some of the parts of your Go-Chair are susceptible to extreme changes in temperature. Always keep

your Go-Chair between the temperatures of 18°F (-8°C) and 122°F (50°C).

 In extremely cold temperatures the batteries may freeze. The speciﬁ c temperature at which they freeze

depends on a number of factors, such as battery charge, usage, and composition of the batteries

(e.g., AGM).

General Guidelines

 Avoid knocking or bumping the controller.

 Avoid prolonged exposure of your Go-Chair to extreme conditions, such as heat, cold, or moisture.

 Keep the controller clean.

 Check all connectors to ensure that they are all tight and secured properly.

 If your travel chair is equippped, make sure pneumatic tires are inﬂ ated to the psi/bar/kPa air pressure

rating indicated on each tire.

WARNING! Make sure pneumatic tires are inﬂ ated to the psi/bar/kPa air pressure rating

indicated on each tire. Do not underinﬂ ate or overinﬂ ate your tires. Low pressure may

result in loss of control, and overinﬂ ated tires may burst. Overinﬂ ating tires can cause

them to explode.

WARNING! Do not use a high pressure hose to inﬂ ate your tires.

 Use a rubber conditioner on the tire sidewalls to help preserve them.

WARNING! Never use a rubber conditioner on the tread areas of the tires; doing so may

make the tires slippery and cause your travel chair to skid.

Care and Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pride Go-Chair Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pride Go-Chair

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info