Bedienungsanleitung Pride Hurricane (Seite 37 von 42) (Englisch)

721999

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Hurricane

Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that

may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because

the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FLASH CODES

The diagnostic flash codes for your Hurricane are designed to help you perform basic troubleshooting quickly and

easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below

develops.

NOTE: Your Hurricane will not run unless the flash code condition is resolved and the Hurricane has been

turned off, then turned back on.

What if all the systems on my Hurricane seem to be dead?

n Make certain that the key is in the on position.

n Check that the batteries are fully charged. See V. Batteries and Charging.

n Push in the main circuit breaker reset button. See IV. Your Hurricane. 

n Make certain that both battery harnesses are firmly connected to the electronics module and to the battery

terminals. See VIII. Disassembly and Assembly.

n Make sure that the silver front-to-rear harness is firmly connected to the electronics module. See VIII.

Disassembly and Assembly.

n Be sure the auto shutoff feature hasnt been activated. See V. Batteries and Charging.

n Check the fuses. See XI. Care and Maintenance for fuse replacement.

What if the motor runs but my Hurricane does not move?

n With the key turned to the on position, check the status LED. If the LED flashes three times, pauses briefly,

then flashes twice, this is the manual freewheel lever code meaning your Hurricane is in freewheel mode. See

table above

n When the manual freewheel lever is pulled up, the brakes are disengaged and all power to the transaxle is cut.

n Push down the manual freewheel lever to restore normal operation to your Hurricane. See IV. Your Hurricane. 

X. BASIC TROUBLESHOOTING

FLASH CODE CONDITION SOLUTION

Batteries are too low to operate the

scooter or the charger is operating.

Charge batteries or unplug the charger power

lead from the electrical outlet.

Controller is hot; the scooter seems to

be losing power.

Shut down your scooter for a minimum of

several minutes to allow the controller to

cool.

Wigwag fault; your throttle control

lever is not responding.

Call your authorised Pride provider for

assistance.

The manual freewheel lever is in the

(up) freewheel position.

Turn the scooter key to the off position, then

push the manual freewheel lever to the

(down) drive position: restart your scooter.

The scooter is operating with the

charger attached.

Unplug the charger lead from the charger

power lead receptacle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pride Hurricane Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info