Bedienungsanleitung Pride Luna Victory E (Seite 40 von 48) (Englisch)

668223

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

40 www.pridemobility.com Luna Victory Series

IX. CARE AND MAINTENANCE

Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your

ability to perform the maintenance listed below, you may schedule inspection and maintenance at your

authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.

TIRE PRESSURE

If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on

each tire.

WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire

be maintained in pneumatic tires at all times. Do not underinflate or overinflate your

tires. Low pressure may result in loss of control, and overinflated tires may burst. Failure

to maintain the psi/bar/kPa air pressure rating indicated on the tires at all times may

result in tire and/or wheel failure.

Regularly inspect your scooter’s tires for signs of wear.

EXTERIOR SURFACES

Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.

WARNING! Do not use a rubber or vinyl conditioner on the scooter’s vinyl seat or tire

tread, as this may cause them to become dangerously slippery.

CLEANING AND DISINFECTION

Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter.

Avoid using products that may scratch the surface of your scooter.

If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for

use on your product before application.

WARNING! Follow all safety instructions for the proper use of the disinfectant and/or

cleaning agent before applying it to your product. Failure to comply may result in skin

irritation or premature deterioration of upholstery and/or scooter finishes.

BATTERY TERMINAL CONNECTIONS

Make certain that the terminal connections remain tight and uncorroded.

The batteries must sit flat in the battery wells.

The battery terminals should face away from the seat post.

WIRING HARNESSES

Regularly check all wiring connections.

Regularly check all wiring insulation, including the charger power cord, for wear or damage.

Have your authorized Pride Provider repair or replace any damaged connector, connection, or

insulation that you find before using your scooter again.

PROHIBITED! Even though the scooter has passed the necessary testing requirements

for ingress of liquids, you should keep electrical connections away from sources of

dampness, including direct exposure to water or bodily fluids and incontinence. Check

electrical components frequently for signs of corrosion and replace as necessary.

WARNING! Do not pull on electrical harnesses directly to detach them from the scooter.

Always grasp the connector itself when disconnecting the harness to prevent wire

damage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pride Luna Victory E Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pride Luna Victory E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info