Bedienungsanleitung Pride QUANTUM 610 (Seite 21 von 32) (Englisch)

668245

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Quantum 610 Series www.pridemobility.com 21

VI. BATTERIES AND CHARGING

To charge the batteries using the off-board charger:

1. Position the front of your power chair next to a standard

electrical outlet.

2. Be certain the controller power is turned off and the

freewheel levers are in the engaged position. See III.

“Your Power Chair.”

3. Plug the off-board charger into the off-board charger/

programming socket on the controller. See ﬁ gure 19.

4. Plug the off-board charger into the electrical outlet.

WARNING! The LED lights on the charger

indicate different charger conditions at

various times: charger power on, charging in

progress, and charging complete. If the LED

does not indicate that charging is complete

within 24 hours, unplug the charger from

the outlet and contact your Quantum Rehab

provider. Refer to the manual supplied with

the charger for a complete explanation of

these indicators.

5. When the batteries are fully charged, unplug the off-

board charger from the electrical outlet and then from

the controller.

XLR

Figure 19. Battery Charging

Battery Break-in

To break in new batteries for maximum efﬁ ciency:

1. Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak per-

formance level.

2. Operate your power chair throughout the house and yard. Move slowly at ﬁ rst, and do not travel too far until

you become accustomed to the controls and break in the batteries.

3. Give the batteries another full charge of at least 8 to 14 hours and operate your power chair again. The batter-

ies will now perform at over 90% of their potential.

4. After four or ﬁ ve charging cycles, the batteries will top off at 100% charge and last for an extended period.

Frequently Asked Questions

How does the charger work?

The battery charger takes the standard electrical outlet voltage (alternating current) and converts it to 24 VDC

(direct current). The power chair batteries use direct current to run your power chair. When the battery voltage

is low, the charger works harder to charge the battery. As the battery voltage approaches full charge, the charger

does not work as hard to complete the charging cycle. This explains why the ammeter drops as it approaches a full

charge. This is how the charger maintains a charge but does not overcharge the battery.

Can I use a different battery charger?

You should use the charger supplied with the power chair. It is the safest, most efﬁ cient tool to charge the batteries.

We do not recommend using other types of chargers (e.g., an automotive battery charger).

NOTE: Your power chair’s charger will not operate after the batteries have been discharged to nearly zero

voltage. If this happens, call your Quantum Rehab Provider for assistance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pride QUANTUM 610 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info