Do not cover the appliance.
Do not use charcoal or similar combustible
fuels.
Do not let metal cutlery touch the grill plate
to prevent damage to the non-stick coating.
Beware of steam and splashes when
putting food on the hot grill plate.
Caution: Hot grease can splash from the
grill plate.
Do not pour cold water onto the hot grill
plate. The water will splash and damage
the grill plate.
Always be careful when touching the
appliance. Use oven gloves if you need to
touch the appliance during or shortly after
use.
The grill plate becomes very hot during use.
Do not touch the hot grill plate. Only touch
the handgrips when the grill plate is hot.
Make sure that your hands are dry before
touching the appliance.
Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
Do not use the appliance near birds
(e.g. tropical birds such as parrots).
The grill plate is finished with a non-stick
coating based on PTFE. Upon heating,
the coating may release small amounts of
gases which are fully harmless for people.
However, the nervous systems of birds are
extremely sensitive to these gases.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
Never attempt to remove or replace any parts
other than those specified in this manual.
Before use, check the mains cable for wear
or damage.
Do not use the appliance if the mains cable
or mains plug is damaged or defective. If
the mains cable or mains plug is damaged
or defective, it must be replaced by the
manufacturer or an authorised repair agent.
Safety instructions for Table Chef
Before use, always check that the mains
voltage is the same as the voltage on the
rating plate of the appliance.
Connect the appliance to an earthed wall
socket. If necessary, use an earthed
extension cable of a suitable diameter
(at least 3 x 1 mm
2
).
For additional protection, install a residual
current device (RCD) with a rated residual
operating current that does not exceed
30 mA.
The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
Make sure that water cannot enter the
contact plugs of the mains cable and the
extension cable.
Always fully unwind the mains cable and
the extension cable.
Only use the appropriate connector to
operate the appliance.
Place the appliance on a stable and flat
surface.
Place the appliance on a heat-resistant
and splash-proof surface.
Do not place the appliance on a hob.
Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
Make sure that the appliance does not
come into contact with flammable material.
Keep the appliance away from heat sources.
Make sure that the connector does not fall
into water or other liquids. If the connector
falls into water or other liquids, do not remove
the connector with your hands. Immediately
remove the mains plug from the wall socket.
If the connector falls into water or other
liquids, do not use the connector again.