Do not immerse the thermostat in water or
other liquids. Do not remove the thermostat
from the water with your hands. Immediately
remove the mains plug from the wall socket.
If the thermostat is immersed in water or
other liquids, do not use the appliance again.
Do not cover the appliance.
Do not use charcoal or similar combustible
fuels.
Do not let metal cutlery touch the grill plate,
the grill rack and the pans to prevent
damage to the non-stick coating.
Beware of steam and splashes when
putting food on the hot grill plate, the hot
grill rack and the hot pans.
Caution: Hot grease can splash from the
grill plate and the grill rack.
Do not pour cold water onto the hot grill
plate, the hot grill rack and the hot pans.
The water will splash and damage the grill
plate, the grill rack and the pans.
Always be careful when touching the
appliance. Use oven gloves if you need to
touch the appliance during or shortly after
use.
The grill plate, the grill rack and the pans
become very hot during use. Do not touch
the hot grill plate, the hot grill rack and the
hot pans. Only hold the pans by the
handgrips when the pans are hot.
Make sure that your hands are dry before
touching the appliance.
Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
Do not use the appliance near birds (e.g.
tropical birds such as parrots). The grill
plate is finished with a non-stick coating
based on PTFE. Upon heating, the coating
may release small amounts of gases which
are fully harmless for people. However, the
nervous systems of birds are extremely
sensitive to these gases.
Do not use the appliance if any part is
damaged or defective.
Have any damaged or defective part
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace any
parts other than those specified in this
manual.
Before use, check the mains cable for wear
or damage.
Do not use the appliance if the mains cable
or mains plug is damaged or defective.
If the mains cable or mains plug is damaged
or defective, it must be replaced by the
manufacturer or an authorised repair agent.
Safety instructions for Multi Chef
Before use, always check that the mains
voltage is the same as the voltage on the
rating plate of the appliance.
Connect the appliance to an earthed wall
socket. If necessary, use an earthed
extension cable of a suitable diameter
(at least 3 x 1 mm
2
).
For additional protection, install a residual
current device (RCD) with a rated residual
operating current that does not exceed
30 mA.
The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
Make sure that water cannot enter the
contact plugs of the mains cable and the
extension cable.
Always fully unwind the mains cable and
the extension cable.
Only use the appropriate connector to
operate the appliance.
Place the appliance on a stable and flat
surface.
Place the appliance on a heat-resistant
and splash-proof surface.
Do not place the appliance on a hob.
Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
Make sure that the appliance does not
come into contact with flammable material.
Keep the appliance away from heat sources.
