Bedienungsanleitung Princess 332845 (Seite 14 von 82) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

491615

Zoom out

Zoom in

Vorherige Seite

1/82

Nächste Seite

Remote Control Vacuum Cleaner Article 332845

or the crevice tool directly to the end of

vacuum cleaner hose handle.

The combi nozzle has two settings: with

a brush for vacuuming hard floors

(parquet, tiles, linoleum, etc.) and

without a brush for vacuuming soft

floors (carpet, etc.). Press the button on

the combi nozzle to either vacuum with

a brush ( ) or without a brush

( ) (see figure 4).

Vacuuming

1 The power cord has a yellow mark and

a red mark on it (see figure 5). Extend

the power cord beyond the yellow mark.

The red mark indicates the end of the

power cord. Never extend the cord

beyond the red mark. This could

damage the power cord.

2 Insert the plug into a plug socket and

switch ON the appliance with the On/Off

switch.

3 Use the vacuum cleaner tube with

handle to move the nozzle over the

surface to vacuum.

You can pull the appliance back and

forth with the vacuum hose.

You can lift the appliance using the

vacuum cleaner’s handle.

4 Press the On/Off button to switch the

appliance OFF.

Remote Control

You can use the remote control on top of

the vacuum hose handle to control the

vacuum cleaner (see figure 6).

The remote control uses infrared light to

control the vacuum cleaner. Point the

infrared sender (30) to the receiver (31) on

the vacuum cleaner when using the remote

control.

The remote control has three buttons:

Note:

When the appliance is switched OFF with

the ON/OFF switch, the remote control will

not function.

Accessories

Besides the combi nozzle for cleaning

large surfaces, there is also a crevice tool,

to clean radiators, window frames,

crevices, small openings, etc.

The crevice tool is stored on the backside

of the vacuum cleaner.

Storing the appliance

1 Remove the plug from the plug socket.

2 Lightly hold the end of the power cord.

Press the cord rewind button and allow

the cord to gently slide through your

fingers back into the appliance.

Note! You must guide the cord whilst it

is rewinding. If you do not do so, the

cord may become tangled or the plug

may strike the back of the appliance.

This can damage the appliance or the

power cord.

STOP Stops the appliance.

+ Starts up the appliance after it

has been stopped by the STOP

button on the remote control.

When running, each time the +

button is pressed, the power of

the appliance will be increased

till maximum power is reached.

It takes 5 steps to increase from

minimum to maximum power.

- Starts up the appliance after it

has been stopped by the STOP

button on the remote control,

When running above minimum

power, each time the - button is

pressed, the power of the

appliance will be decreased till

minimum power is reached.

It takes 5 steps to decrease from

maximum to minimum power.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Princess 332845 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info