Bedienungsanleitung Privileg PDSI 5081 (Seite 17 von 32) (Deutsch)

491524

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Before using the dishwasher, read the installation and maintenance instructions carefully!

5019 696 01016

PDSI 5081

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:

for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

1. OVERVIEW

Programme selection button

Press the button (repeatedly) until the indicator lamp of the

desired programme lights up (see table 1.1).

At the end of the wash cycle, the last programme selected is

memorized.

Detergent setting upon initial use and when using a different type

of detergent

Indicator lamp off = Powder/gel detergent (factory setting).

If using combined detergents, press and hold the button for 3

seconds; the indicator lamp lights up = rinse aid and salt indicators

are deactivated.

From water hardness level 5, the salt indicator remains active.

At the end of the programme, the most recently selected setting

remains memorised.

Delayed start button

Press the button repeatedly to delay the start of the programme

by 2, 4 or 8 hours. Then press the Start/Resume button. The

remaining time is indicated by the corresponding indicator lamp.

The wash programme will start after the set time. The set delay

will be memorised at the end of the cycle, and can be selected by

pressing the button again.

Start/Resume button

The indicator lamp lights up during operation, flashes when

the programme is interrupted before completion and

switches off at the end of the programme.

Cancel/Off button

Press the button to switch the dishwasher off or to interrupt

the selected programme.

If the Cancel/Off indicator lamp flashes repeatedly, this

indicates a fault: see chapter 5 “What to do if...”.

Salt level indicator and rinse aid level indicator

These light up at the end of the programme if salt or rinse aid

needs topping up.

Only add just before starting a wash cycle.

Table 1.1.

Overview of programmes

Detergent

dispenser

Consumption

Programmes

Available

options

Description of programme large small Litres kWh Minutes

PRE-RINSE cold

Crockery to be washed later. — — 4.0 0.03

14 ±

QUICKWASH 45°C

Lightly soiled crockery, with no dried-on

food.

X — 11.0 0.80

30 ±

ECO

50°C

Normally soiled crockery.

Energy-saving programme.

X X 13.0 1.05

165 ±

INTENSIVE 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pots and pans.

X X 14.0 1.55

155 ±

1/2 LOAD 50°C

Ideal for washing a half load of lightly or

normally soiled crockery.

X X 10.0 1.04 145 ±

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Privileg PDSI 5081 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info