Bedienungsanleitung Privileg PRC551 (Seite 17 von 76) (Deutsch, Englisch, Holländisch, Französisch)

712225

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Installation instructions for product with Hettich hinges

! It is recommended that this installation be performed by authorized technical stuff.

! Before installation, read the instructions carefully.

! Fit the refrigerator/freezer in stable kitchen units only.

! Cabinet dimensions are changed by material of trim ap

1. If material of trim ap

(1)

is plastic, look at (Table.1/B1) for cabinet dimensions.

2. If material of trim ap

(1)

is metal, look at (Table.1/B2) for cabinet dimensions.

! If necessary, reverse the door according to instructions.

1. See g.A for the necessary attachment components.

2. Open the package. Take gasket spacer

(9)

and brake into three as shown in gureD.

Themiddle part is door hang rail

(10)

. The other two parts are unit door spacers

(11)

. (g.D)

3. Insert trim ap

(1)

into slot and screw by screws

(8)

. (g.E)

4. Pass the power cord through ventilation shaft and position it so that the appliance could-

be easily plugged in once it has been installed. (g.B - g.C)

5. Cut trim gasket

(4)

to the height of the recess and stick it on reverse side of the doorhin-

ges of the appliance. (g.E)

6. Raise the appliance and slide into the kitchen unit.

7. Lean the appliance to the kitchen unit through the hinges and align the front feet with

frontsurface of the kitchen unit. (g.F)

8. Open the appliance door and screw the front feet by using screws

(7)

. (g.G)

9. Screw trim ap

(1)

to kitchen unit using screws

(7)

. (g.G)

10. Screw the hinges to the kitchen unit using screws

(7)

. (g.G)

11. Close the appliance door. Unscrew and remove the nuts

(14)

, washers

(13)

and adjustmen-

tbolts

(12)

from the appliance door. (g.H)

12. Remove the liner for the adhesive part on the door hang rails

(10)

. Place door hang

rails

(10)

on theappliance door by inserting the bosses on the holes of the appliance door,

aligning thefront surfaces of the door hang rails(

10)

and the appliance door parallel to

each other. Letthe door hang rails

(10)

, stick onto the appliance door. (g.H)

13. Slide the door hang

(2)

into door hang rails

(10)

. (g.J - g.K)

14. Take out the liners of the adhesive part on the front side of the door hang

(2)

15. Take out the liners of the adhesive part on the unit door spacers

(11)

and and stick them

onto theunit door(15), closer to the upper corners. (g.K)

16. Lean the unit door

(15)

to the door hang

(2)

, aligning the unit door spacers(11) on the

left,right and top edges with the sides of the unit or the doors of the nearer and upper

kitchenunits. (g.K)

17. Make sure that the unit door

(15)

sticks onto the door hang

(2)

. Pull the unit door

(15)

al-

lowing the door hang

(2)

to slide out the door hang rails

(10)

. Observe that the door hang

(2)

stays stuck on the unit door

(15)

. (g.L)

18. Lay down the unit door

(15)

on the oor and screw the door hang

(2)

to the unit door

(15)

screws

(7)

. (g.L)

19. To overcome some of the furniture mistakes, there are plastic spacers

(A)

sticked on the

door hang

(2)

. Remove these plastic spacers

(A)

. (g.M)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Privileg PRC551 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info