Bedienungsanleitung Pro-form LE DE TOUR FRANCE BIKE - PFEX19810 (Seite 23 von 28) (Englisch)

553939

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

HOW TO MAINTAIN THE EXERCISE BIKE

Inspect and tighten all parts of the exercise bike regu-

larly. Replace any worn parts immediately.

To clean the exercise bike, use a damp cloth and a

small amount of mild detergent. IMPORTANT: To

avoid damage to the console, keep liquids away

from the console and keep the console out of

direct sunlight.

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, the drive belt

may need to be adjusted.

See the EXPLODED DRAWING on page 27 to identify

the parts mentioned below.

To adjust the Drive Belt (66), first press the power

switch to the off position and unplug the power

cord.

Use a flat screwdriver and remove the Upper Shield

(10) and the right Shield Cover (13).

Next, remove the #8 x 32 x 13mm Screw (88) from the

Right Shield (12). Then, remove the #8 x 3/4" Screw

(94) from the Left Shield (11).

Then, use a socket set to remove the two 1/4" Flange

Nuts (99) from the Right Shield (12).

Remove the two #8 x 1/2" Screws (95) on the right

side of the Electronics Shield (98). Then, gently move

the Right Shield (12) away from the exercise bike.

Locate the Idler Pulley (37). Loosen the 3/8" Jam Nut

(71). Then, tighten the Idler Adjustment Screw (39)

until the Drive Belt (66) is tight.

When the Drive Belt (66) is tight, tighten the 3/8" Jam

Nut (71).

Reattach the Right Shield (12) with the #8 x 1/2”

Screws (95), the 1/4" Flange Nuts (99), the #8 x 3/4"

Screw (94), and the #8 x 32 x 13mm Screw (88).

Then, reattach the Upper Shield (10) and the right

Shield Cover (13).

MAINTENANCE AND TROUBLESHOOTING

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from the circuit to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to

computer or peripheral devices. Changes or modifications not expressly approved by the party respon-

sible for compliance could void the user's authority to operate this equipment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pro-form LE DE TOUR FRANCE BIKE - PFEX19810 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info