3
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (A) from the Console Back (B).
2. Peel the paper off the pad on the bottom of the Receiver
(C). Turn the Receiver so the cylinder is on the side
shown, and press the Receiver into the bottom of the
Console Back (B) in the indicated location.
Connect the included Short Jumper Wire (D) to the wire on
the Receiver (C). Connect the other end of the Short
Jumper Wire to the PULSE jack on the back of the Console
(E). Note: The other wires included with the receiver may
be discarded. The Wire Tie can be used to tie wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (E) with the Screws (A).
B
E
A
1
2
PULSE
Jack
D
E
C
B
Cylinder
