5
2
75
1
72
28
56
1. Attach the Front Stabilizer (2) to the front of the
Frame (1) with two M8 x 70mm Carriage Bolts (72),
two M8 Curved Washers (28), and two M8 Nylon
Locknuts (56). Make sure that the Front Stabilizer is
turned so the Roller (75) is not touching the floor.
2. Attach the Rear Stabilizer (3) to the rear of the
Frame (1) with two M8 x 80mm Carriage Bolts (63),
two M8 Curved Washers (28), and two M8 Nylon
Locknuts (56).
3. While a second person holds the Handlebar Post (6)
near the Frame (1) as shown, connect the Upper
Wire Harness (16) to the Lower Wire Harness (87).
Carefully slide the Handlebar Post (6) onto the
Frame (1). Be careful to avoid pinching the Wire
Harnesses (16, 87). Attach the Handlebar Post to
the Frame with four M8 x 15mm Button Screws (27)
and four M8 Curved Washers (28).
2
3
63
3
6
27
27
28
1
16
87
28
4. The Console (9) requires two “AA” batteries (not
included); alkaline batteries are recommended.
Remove the Battery Cover (17) from the back of the
Console. Press two batteries into the battery clip as
shown in the inset drawing. Make sure that the
negative (–) ends of the batteries are touching
the springs. Reattach the Battery Cover.
Connect the two Pulse Wires (22) to the two wires
extending from the Console (9). Next, connect the
Upper Wire Harness (16) to the back of the Console.
Insert all wires into the Handlebar Post (6).
Attach the Console (9) to the Handlebar Post (6)
with four M4 x 10mm Screws (21).
17
9
22
16
Console
Wires
6
21
4
28
28
56
56
1
Batteries
Battery
Clip
1
