Bedienungsanleitung Proficare BS 3110 (Seite 34 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814757

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

PC-BS3110_IM 06.10.22

Filter Insert

CAUTION:

• Never wash the lter in the washing machine.

• Do not use a hairdryer for drying.

• Only use the appliance after the lters have been

installed correctly.

Proceed as follows to remove, clean and reinstall the lter

insert:

1. Empty the dust collector as described previously.

2. Remove the dust collector lid. Turn it anticlockwise in the

direction of .

NOTE:

The markings “ ” and “ ” are imprinted on the right

side of the dust container.

3. Remove the ne dust lter. Remove the foam insert from

the ne dust lter.

4. Remove the coarse dirt lter from the dust collector. To

do this, reach into the recesses of the lter and remove

it by pulling it upwards.

5. Use a brush to clean the lters. In case of heavy stain-

ing, clean the lters under running water.

6. Let the lters air-dry completely before retting them!

7. Wipe the dust collector with a damp cloth and then wipe

it dry.

NOTE:

If moisture gets into the rubber seal of the base plate,

carefully remove the seal and dry it as well as the

base plate. Replace the seal.

8. Put the coarse dirt lter back into the collector. Make

sure that the guides are seated in the openings.

NOTE:

The recesses are made in such a way that the

guides t in one position only. This prevents incorrect

assembly.

9. Insert the foam insert into the ne dust lter. The smooth

side must be visible.

Place the ne dust lter onto the coarse dirt lter.

10. Put the lid back on the dust collector. The guides must

t into the openings. Press it gently and turn it clockwise

until it clicks into position.

NOTE:

The recesses are made in such a way that the

guides t in one position only. This prevents incorrect

assembly.

Check the correct t of the cover. The attened side of

the handle must t over the hose connector.

11. Fit the dust collector in the appliance.

Outlet Filter

The appliance is also equipped with an outlet lter.

It is located on the back of the unit next to the parking aid.

1. Push down the lever (10) and remove the ventilation

grille.

2. Remove the lter insert and clean it. You can brush out

the lter.

3. Reinsert the lter. The guide eyes have to point up-

wards.

4. Put the ventilation grille back on the appliance. Observe

the guide lugs. The ventilation grid must engage audibly.

Cleaning

WARNING:

• Pull the mains plug out of the socket before cleaning or main-

taining the appliance.

• Under no circumstances should you immerse the appliance in

water for cleaning purposes. Otherwise this might result in an

electric shock or re.

CAUTION:

• Do not use a wire brush or any abrasive items.

• Do not use any acidic or abrasive detergents.

Clean the housing with a soft, dry cloth without additives.

Storage

• Let the appliance cool down completely.

• Wind the cable completely.

• Please insert the hook of the oor nozzle into the parking

assistant on the rear of the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proficare BS 3110 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info