Bedienungsanleitung Proficare MS 3079 (Seite 27 von 46) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814763

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

PC-MS3079_IM 20.04.20

Using the Appliance

NOTE:

• Always test the appliance on a small, insignicant spot

rst.

• Make sure to always clean mattresses on both sides.

1. Insert the mains plug into a correctly installed power

socket.

2. Place the appliance on the surface to be cleaned.

3. Use the on / off switch to put the appliance into

operation.

4. Press and hold the vibration button on the bottom of the

handle. The surface to be cleaned is shaken due to the

vibration and the dust will be sucked up. In addition, the

UV-C lamp turns on.

5. Move the appliance slowly and evenly over the surface

to be cleaned.

6. Maintain an offset when positioning the appliance as the

track width of the suction is limited by design.

7. Use the on / off switch to put the appliance out of

operation.

Maintenance

NOTE:

Replace the lter and the UV-C lamp whenever the need

arises.

Emptying the Dust Container

Empty the dust container after each use.

1. Disconnect the mains plug from the socket.

2. Remove the dust container by pulling it up via the

handle.

3. Then remove the lter from the dust container.

4. Empty the dust container.

5. Place the lter back into the dust container.

6. Put the dust container back into the appliance.

Replace UV-C Lamp whenever the Need Arises

In case the UV-C lamp is defective, you can replace it.

1. Disconnect the mains plug from the socket.

2. Loosen the screw on the cover that is located at the

bottom of the appliance using a Phillips screwdriver.

3. Remove the cover.

4. The UV-C lamp is attached to two pin bases. Carefully

pull them up and detach the UV-C lamp from the pin

bases. Replace it with a UV-C lamp of the same type.

5. Put the UV-C lamp back in a reverse order and reattach

the cover.

Cleaning

WARNING:

• Before cleaning remove the mains lead from the socket.

• Under no circumstances should you immerse the appliance in

water for cleaning purposes. Otherwise this might result in an

electric shock or re.

CAUTION:

• Do not use a wire brush or any abrasive items.

• Do not use any acidic or abrasive detergents.

Clean the housing with a soft, dry cloth without additives.

Dust Container and HEPA Filter

1. Remove the dust container by pulling it up via the

handle.

2. Then remove the lter from the dust container.

3. Empty the dust container. Rinse, if necessary.

4. Brush out the lter. If heavily soiled, you may clean the

lter under running water.

5. Allow all parts to dry completely before putting them back

into the appliance!

6. Place the lter back into the dust container.

7. Put the dust container back into the appliance.

Storage

• Clean the appliance as described and allow it to dry.

• We recommend that you keep the appliance in the origi-

nal packaging if it will not be used for long periods.

• Always store the appliance out of the reach of children in

a dry, well ventilated place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proficare MS 3079 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info