Bedienungsanleitung Proficare R 3013 (Seite 33 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814839

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

PC-HSM-R3013_IM 11.01.18

• After initial use, do not charge the battery for longer than

10 hours at one time.

CAUTION:

After 10 hours always disconnect from mains power

supply.

NOTE:

You can extent the lifetime of the rechargeable battery by

following these steps:

• Only charge after the battery is nearly exhausted.

• Do not charge for more than 10 hours.

• Charge the appliance at temperatures between 0 °

and + 40 °C.

• In case the rechargeable batteries are faulty, replace

them with two new ones of the same types. Observe the

details under “Technical Data”.

Using the Appliance

Switching On and Off

Slide the switch to turn the appliance on or off.

Adjust Cutting Length

1. Turn off the appliance. “ON” can be seen on the switch.

Number Cutting length

in mm

1approx. 4

2approx. 10

3approx. 14

4approx. 18

2. Select a comb attach-

ment. The comb attach-

ments are labelled with

numbers.

3. Attach the desired

comb: Also refer to g-

ure B on page 3. Slide

the blades of the clipper

head into the jags of the comb.

4. To remove the comb attachment, pull it off the clipper

head.

Cut Hair and Beard

WARNING: Risk of injury!

Do not press the shaving head of the hair / beard trimmer

too rmly against the skin.

NOTE:

• Only cut dry hair with this appliance.

• Start by using the biggest comb attachment and cut

your hair / beard step by step to the desired length.

1. Select the cutting length with a comb attachment.

2. Turn the appliance so that you are able to see the back.

Set the switch (2) to the left position.

3. Switch the appliance on. “OFF” can be seen on the

switch.

Thinning out Your Hair

This appliance has a thin-out function.

• Use the appliance with a comb attachment.

• The different positions of the switch (2), you will be able

to produce different results.

Outlining and Shaving the Neck

• Use the appliance without a comb attachment.

• Set the switch (2) to the left position.

• The shaving head allows for precisely outlining the

beard contours, as well as a clean shaving of the hair

line at the neck.

Finish Operation

Turn the appliance off.

Cleaning

WARNING:

• Switch off the appliance before cleaning. Disconnect the power

adapter from the electrical outlet.

• Do not submerge the appliance in water!

• Do not immerse the power adapter in water!

CAUTION:

• Also do not clean the appliance under running water!

The electronics could get damaged.

• Do not use a wire brush or other abrasives.

• Do not use sharp or abrasive cleaning agents.

• Use the cleaning brush to remove remaining hair after

use.

• Clean the casing with a slightly damp cloth, if necessary.

• Always clean the power adapter with a dry cloth.

• Regularly apply 1 - 2 drops acid-free oil onto the blades

of the clipper head.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proficare R 3013 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info