Bedienungsanleitung ProfiCook DR 1116 (Seite 41 von 70) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

686167

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

PC-DR1116_IM_K4 25.07.16

Operation of the Appliance

Location

• Place the machine on the dry, non-slip surface.

• Take care that the appliance and the mains cable

never are placed onto hot surfaces or near heat

sources (e.g. range, hob).

Assembly

• If you want to use only one sieve tray, please use

the one with the closed air duct. You see the inscrip-

tion “COUVERCLE TOP TAPA SUPERIOR”.

• If you use several sieve trays, the sieve tray with

the closed air duct needs to be placed in the upper

position.

• Use the appliance only with the lid closed.

Electric Connection

Before inserting the power plug into the outlet, check

that the mains voltage to be used matches that of the

appliance. You can nd the required information on the

nameplate.

Use

1. Connect the appliance to a tested socket. The

appliance is in standby mode. The display will show

“Hr” for “hours” and the number of hours “00” ash.

2. Press the TIME / TEMP button. You will see the

preset temperature “55 °C”.

NOTE:

If you want to change the temperature unit to “°F”

change, hold the TIME / TEMP button pressed

down for about 3 seconds. This change is only

possible in standby mode.

3. Press the button “

” or “ “ to set the desired

temperature. With each press on the button, the

temperature increases or decreases by 5 °.

4. Press TIME/TEMP. The display will ash “00”.

5. Press the button “

” or “ “ to set the desired

dehydrating time. With each press on the button,

the time increases or decreases by 1 hour. If you

hold the button “ ” or “ “ pressed, a fast mode

will start.

6. Press the START/PAUSE button to switch on the

appliance. In the display, you will see the symbol .

NOTE:

• During operation, the remaining time and the

set temperature are alternately indicated in the

display.

• To interrupt the operation, press once briey

the START / PAUSE button. The display will

ash "PA". If you want to continue the opera-

tion, press again the button START / PAUSE.

• You can change the temperature or the dehy-

drating time at any time during operation by

using the TIME / TEMP button. But please note:

Once you increase or decrease the time, the

full-hour countdown will start from the begin-

ning. The minutes during which the appliance

has already been in operating mode will not be

considered.

Stop Operation

• When the set time has elapsed in the timer, the

appliance automatically switches to standby mode.

The heating and the fan will stop. The display will

show “00”.

• You can also previously cancel the operation at

any time. Hold the START / PAUSE button pressed

down for about 3 seconds.

• Disconnect the mains plug from the socket.

Cleaning

WARNING:

• Always remove the mains lead before cleaning!

• Wait until the machine has cooled down completely!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ProfiCook DR 1116 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info