814886
35
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
35
Electrical connection
WARNING:
The installation to the mains supply must conform
to the local standards and regulations.
Improper connection may cause to an electric
shock!
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for approx. four hours before connecting to
the power supply. Nonobservance could lead to mal-
function of the cooling system and causes an appli-
ance breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter
“Cleaning and Maintenance”
.
Starting the appliance
Connect the appliance to the power supply.
Set the desired indoor temperature. Read the
following sections.
Operation overview
1 Display
2 Switch interior lighting on and off
3 Increase temperature stepwise by 1°C (1°F)
4 Decrease temperature stepwise by 1°C
(1°F)
3+4
Switch display between °C and °F
Press the button (2) to switch the interior lighting
off and on again.
The indoor lighting will turn off automatically after
about 10 minutes, saving energy.
Use the buttons (3) and (4) to set the interior tem-
perature. The display (1) shows the selection.
A few seconds after the last button press, the
temperature display will automatically change to
the actual temperature value currently in the ap-
pliance.
The next time the button is pressed, the display
will first show the last set temperature value.
By pressing the button combination (3+4), you
can change the temperature display to Fahrenheit
or Celsius.
Settings
The temperature value is adjustable between:
+11°C to +18°C (+52°F to +65°F)
The reachable value cannot be higher than the am-
bient temperature at the place of installation.
During initial startup, longer standstill of the device or
temperature adjustment, there may be a deviation of
a few degrees between the temperature you have
selected and the temperature shown on the display.
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für ProfiCook WK 1233 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info