Bedienungsanleitung Progress PDI1006E (Seite 16 von 144) (Alle Sprachen)

638776

Zoom out

Zoom in

Vorherige Seite

1/144

Nächste Seite

16 progress

will help prevent potential negative

consequences for the environment

and human health, which could

otherwise be caused by inappropriate

waste handling of this product.

The symbol

on the product, or on

the documents accompanying the

product, indicates that this appliance

may not be treated as household

waste. Instead it should be taken to

the appropriate collection point for the

recycling of electrical and electronic

equipment. Disposal must be carried

out in accordance with local environ-

mental regulations for waste disposal.

For further detailed information

regarding the process, collection

and recycling of this product, please

contact the appropriate department

of your local authorities or the local

department for household waste or

the shop where you purchased this

product.

Use

The hood is designed to be used either for

exhausting

or ﬁ lter version .

Installation

This type of cooker hood must be ﬁ xed to

the ceiling.

Very heavy product; hood handling and

installation must be carried out by at least

two persons.

The minimum distance between the

supporting surface for the cooking

equipment on the hob and the lowest part

of the range hood must be not less than

50cm from electric cookers and 65cm from

gas or mixed cookers.

If the instructions for installation for the gas

hob specify a greater distance, this must be

adhered to.

The mains power supply must correspond

to the rating indicated on the plate situated

inside the hood. If provided with a plug

connect the hood to a socket in compliance

with current regulations and positioned in

an accessible area, after installation. If it not

ﬁ tted with a plug (direct mains connection)

or if the plug is not located in an accessible

area, after installation, apply a double pole

switch in accordance with standards which

assures the complete disconnection of the

mains under conditions relating to over-

current category III, in accordance with

installation instructions.

Warning! Before re-connecting the

hood circuit to the mains supply and

checking the efficient function, always

check that the mains cable is correctly

assembled.

The hood is provided with a special power

cable ; if the cable is damaged, request a

new one from Technical Service.

Operation

Use the high suction speed in cases

of concentrated kitchen vapours. It is

recommended that the cooker hood

suction is switched on for 5 minutes

prior to cooking and to leave in operation

during cooking and for another 15 minutes

approximately after terminating cooking.

T1T6 T2 T3 T4 T5

L1 L3

L2 L4

T1. Lights ON/OFF

T2. Speed decrease

Press “T2” button to decrease the

speed from 4 (intensive) to 1.

Press “T2” button during operation at

speed 1, the hood sets to OFF.

T3. Speed increase

Press T3 button and the hood sets

from OFF to speed 1.

Press the button (hood is ON) to

increase the the speed of the motor

from speed 1 to the intensive speed

(timed).

Speed 1 LED L1

Speed 2 LED L1+L2

Speed 3 LED L1+L2+L3

Intensive speed (timed) LED

L1+L2+L3+L4 flashing

Note: Speed 4 (intensive timed)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Progress PDI1006E Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info