Bedienungsanleitung Progress pkg 1440 (Seite 22 von 60) (Deutsch, Englisch, Holländisch, Französisch)

345227

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

charging must therefore only be carried

out by authorized technicians.

Periodic cleaning

The equipment has to be cleaned regularly:

• clean the inside and accessories with luke-

warm water and some neutral soap.

• regularly check the door seals and wipe

clean to ensure they are clean and free

from debris.

• rinse and dry thoroughly.

Important! Do not pull, move or damage any

pipes and/or cables inside the cabinet.

Never use detergents, abrasive powders,

highly perfumed cleaning products or wax

polishes to clean the interior as this will dam-

age the surface and leave a strong odour.

Clean the condenser (black grill) and the

compressor at the back of the appliance with

a brush or a vacuum cleaner. This operation

will improve the performance of the appli-

ance and save electricity consumption.

Important! Take care of not to damage the

cooling system.

Many proprietary kitchen surface cleaners

contain chemicals that can attack/damage

the plastics used in this appliance. For this

reason it is recommended that the outer cas-

ing of this appliance is only cleaned with

warm water with a little washing-up liquid

added.

After cleaning, reconnect the equipment to

the mains supply.

Defrosting of the refrigerator

Frost is automatically eliminated from the

evaporator of the refrigerator compartment

every time the motor compressor stops, dur-

ing normal use. The defrost water drains out

through a trough into a special container at

the back of the appliance, over the motor

compressor, where it evaporates.

It is important to periodically clean the defrost

water drain hole in the middle of the refriger-

ator compartment channel to prevent the

water overflowing and dripping onto the food

inside. Use the special cleaner provided,

which you will find already inserted into the

drain hole.

Defrosting the freezer

A certain amount of frost will always form on

the freezer shelves and around the top com-

partment.

Defrost the freezer when the frost layer rea-

ches a thickness of about 3-5 mm.

Important! About 12 hours prior to

defrosting, set the Temperature regulator

toward higher settings , in order to build up

sufficient chill reserve for the interruption in

operation.

To remove the frost, follow the instructions

below:

1. Switch off the appliance.

2. Remove any stored food, wrap it in sev-

eral layers of newspaper and put it in a

cool place.

Caution! Do not touch frozen goods

with wet hands. Hands can freeze to the

goods.

3. Leave the door open and insert the plas-

tic scraper in the appropriate seating at

the bottom centre, placing a basin un-

derneath to collect the defrost water

In order to speed up the defrosting proc-

ess, place a pot of warm water in the

freezer compartment. In addition, re-

move pieces of ice that break away be-

fore defrosting is complete.

22 progress

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Progress pkg 1440 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info