Bedienungsanleitung Proline CDEP70-E (Seite 34 von 60) (Englisch, Holländisch, Französisch)

474784

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

tainer at the community waste disposal fa-

cilities.

Environmental tips

• In the dryer, laundry becomes fluffy and

soft. Fabric softeners are not therefore

needed when washing.

• Your dryer will function most economical-

ly if you:

– always keep the ventilation slots on the

base of the dryer unobstructed;

– use the loading volumes specified in

the programme overview;

– ensure you have good ventilation in the

installation room;

– clean the filter after each drying cycle;

– spin the laundry well before drying.

Energy consumption depends on spin-

ning speed set in washing machine.

Higher spinning speed - lower energy

consumption.

Installation

Appliance positioning

• It is recommended that, for your conven-

ience, the machine is positioned close to

your washing machine.

• The tumble dryer must be installed in a

clean place, where dirt does not build up.

• Air must be able to circulate freely all

round the appliance. Do not obstruct the

front ventilation grille or the air intake

grilles at the back of the machine.

• To keep vibration and noise to a mini-

mum when the dryer is in use, it should

be placed on a firm, level surface.

• Once in its permanent operating position,

check that the dryer is absolutely level

with the aid of a spirit level. If it is not,

raise or lower the feet until it is.

• The feet must never be removed. Do not

restrict the floor clearance through deep-

pile carpets, strips of wood or similar.

This might cause heat built-up which

would interfere with the operation of the

appliance.

Important! The hot air emitted by the

tumble dryer can reach temperatures of up

to 60°C. The appliance must therefore not

be installed on floors which are not resistant

to high temperatures.

When operating the tumble dryer, the room

temperature must not be lower than +5°C

and higher than +35°C, as it may affect the

performance of the appliance.

Warning! Should the appliance be

moved, it must be transported

vertically.

Warning! The appliance must not be

installed behind the lockable door, a

sliding door or a door with a hinge on

the opposite side to that of the

appliance.

The feet must never be removed. Do not

restrict the floor clearance through deep-

pile carpets, strips of wood or similar. This

might cause heat build-up which would in-

terfere with the operation of the tumble dry-

er in such a way that the full opening of the

tumble dryer door is not restricted.

Ensure min. 5cm free space around the ap-

pliance.

Removing transport safety packaging

Caution!

Before use all the transport packaging must

be removed.

1. Open loading door

2. Pull off adhesive strips from inside ma-

chine on top of drum.

3. Remove foil hose and polystyrene pad-

ding from the machine.

Electrical connection

Details on mains voltage, type of current

and the fuses required should be taken

from the type plate. The type plate is fitted

near the loading aperture (see “Product de-

scription” chapter).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proline CDEP70-E Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info