Downloaded from www.vandenborre.be
4
INSTALLATION
Position the appliance and allow it to stand for two to three hours before it is turned on for
the first time to allow the system to settle. Do not position next to any heat source e.g.
cooker, boiler or in direct sunlight etc.
Allow at least 10cm of space at the top and 10 cm of space on both sides of the appliance
and between the back of the appliance and the wall for adequate air circulation. The
appliance is not designed for recessed installation (“building in”).
Install on a good firm level surface, and any unevenness of the floor should be corrected
prior to installation, slight unevenness can be overcome by adjusting the front feet.
NOTE
NOTE
NOTE
NOTE: If the appliance is positioned on a carpet, soft floor covering you should readjust
the front feet on ce the appliance has had time to settle.
OPERATION
This appliance is designed to operate in ambient temperature between 16
℃
and 38
℃
. If
these temperatures are exceeded, i.e. colder or warmer, the appliance will not operate
correctly. If the ambient temperatures are exceeded for long periods, the temperature in the
fridge will rise above 4℃ and food spoilage may occur.
Remove all packaging materials from the appliance. Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5ml to 0.5 litre of water). Dry the appliance
thoroughly.
When you use the fridge for the first time or after defrosting, set the thermostat to the
maximum position for at least 2 hours, and then readjust to the normal position.
Setting
Setting
Setting
Setting the
the
the
the temperature
temperature
temperature
temperature control
control
control
control
Therefrigerator is controlled with a temperature control knob located inside the appliance,
towards the upper right-hand corner. Turn the knob clockwise from the STOP (0) position
towards the higher numbers for colder temperatures.
Higher settings on the knob (higher numbers) mean lower temperatures (colder) in all
compartments of the appliance.
Changes of the ambient temperature affect temperature in the interior of the appliance so
choose a correct setting of the temperature control knob, depending on your ambient
conditions.
In the STOP (0) position the appliance does not operate (the cooling system is switched
