Bedienungsanleitung Proline PLC 102 (Seite 14 von 36) (Deutsch, Englisch, Holländisch, Französisch)

495822

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Downloaded from www.vandenborre.be

warm water with a little washing-up liquid

added.

Defrosting the freezer

Defrost the freezer when the frost layer rea-

ches a thickness of about 10-15 mm.

The best time to defrost the freezer when it

contains no or only a little food.

To remove the frost, do these steps:

1. Switch off the appliance.

2. Remove any stored food, wrap it in

several layers of newspaper and put it

in a cool place.

3. Leave the lid open , remove the plug

from the defrost water drain and collect

all defrost water on a tray. Use a scra-

per to remove ice quickly.

4. When defrosting is completed, dry the

interior thoroughly and refit the plug.

5. Switch on the appliance.

6. Set the temperature regulator to obtain

the maximum coldness and run the ap-

pliance for two or three hours using this

setting.

7. Reload the previously removed food in-

to the compartment.

Important! Never use sharp metal tools to

scrape off frost as you could damage the

appliance. Do not use a mechanical device

or any artificial means to speed up the

thawing process other than those

recommended by the manufacturer. A

temperature rise of the frozen food packs,

during defrosting, may shorten their safe

storage life.

The amount of frost on the walls of the ap-

pliance will be increased by the high level of

the outer environment humidity and if the

frozen food is not wrapped properly.

Periods of non-operation

When the appliance is not in use for long

periods, take the following precautions:

1. Switch off the appliance.

2. Disconnect the mains plug from the

mains socket.

3. Remove all food.

4. Defrost and clean the appliance and all

accessories.

5. Leave the lid open to prevent unpleas-

ant smells.

Important! If the cabinet will be kept on,

ask somebody to check it once in a while to

prevent the food inside from spoiling in

case of a power failure.

WHAT TO DO IF…

Caution! Before troubleshooting,

disconnect the power supply.

Only a qualified electrician or compe-

tent person must do the troubleshoot-

ing that is not in this manual.

Important! There are some sounds during

normal use (compressor, refrigerant

circulation).

Problem Possible cause Solution

The appliance is noisy The appliance is not supported

properly

Check if the appliance stands sta-

ble (all the four feet should be on

the floor)

The compressor oper-

ates continually

The temperature is not set cor-

rectly.

Set a warmer temperature

The lid has been opened too fre-

quently

Do not leave the lid open longer

than necessary

The lid is not closed properly Check if the lid closes well and

the gaskets are undamaged and

clean

Large quantities of food to be

frozen were put in at the same

time

Wait some hours and then check

the temperature again

Food placed in the appliance

was too warm

Allow food to cool to room tem-

perature before storing

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proline PLC 102 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info