Bedienungsanleitung Proline PLC 235 (Seite 56 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

453383

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Downloaded from www.vandenborre.be

IMPORTANT INFORMATION:

 This appliance is designed to operate in ambient temperatures (surrounding air temperature)

between 16 and 32

C If these temperatures are exceeded i.e., colder or warmer, the appliance

will not operate correctly. Should the ambient temperatures be exceeded for long periods, the

temperature in the freezer section will rise above -18 and food spoilage may occur.

 Remove all packaging materials from the appliance. Wash the inside of the cabinet with

lukewarm water and bicarbonate of soda (5ml to 0.5 litre of water). Dry the appliance thoroughly.

 When using the freezer for the first time or after defrosting, turn the thermostat control to the

maximum position for at least 2 hours before introducing food to be stored, and then readjust to

the normal position.

 If there is a power failure, do not open the door. Frozen food should not be affected if the failure

lasts for less than 12 hrs. If the failure is longer, then the food should be checked and either

eaten immediately or cooked and then re-frozen.

DISPOSAL:

As old refrigeration appliances may contain CFC's which will damage the ozone layer,

when disposing of any refrigeration appliance please contact your local waste disposal

department for advice on the correct method of disposal.

The refrigerating gas contained in the circuit of this appliance is Isobutene (R600a);

it causes a low level of pollution but is inflammable.

Please contact your local disposal

department for advice on the correct method of disposal.

INSTALLATION:

This appliance must be position on a flat stable surface; any unevenness can be rectified by adjusting

the two front feet by screwing them in or out.

Do not position this appliance in an excessively cold our damp areas such as a garage or cellar

etc.

Do not locate your freezer near a heat source, EG cooker, boiler or radiator. Also avoid direct

sunlight.

Position the appliance and allow to stand for two to three hours before it is turned on

for the first time to allow the system to settle.

A clearance of 10 cm must be left between the sides of the appliance and any

adjacent cabinets or walls to allow for adequate air circulation. The appliance is not

designed for recessed installation (“building in”).

NOTE: If the appliance is positioned on a carpet, soft floor covering you should

readjust the front feet once the appliance has had time to settle.

This appliance is supplied with two wall spacers that must be installed be inserting them into the two

holes in the appliance top at the back of the unit, by turning them in a 45

direction.

This is to prevent the appliance being pushed to close to the wall.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proline PLC 235 Seite 56

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info