Bedienungsanleitung Proosten ProMax 200 - Software V1.3.1 (Seite 15 von 43) (Deutsch, Englisch, Holländisch)

527014

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

English



Charge time monitoring

When the charger is set for a ‘stand alone’ application, the duration of the charging

process is monitored. If the boost and equalize phase together take more than 14 hours,

the charging process will be stopped. This way it can be prevented a broken battery will

be charged continuously. But with this feature it also can become clear that the charge

current isn’t in the correct proportion to the battery capacity (the battery can become

damaged when the charge process takes too long).

Voltage drop compensation

The battery charger automatically compensates for the voltage drop over the connection

cables. Because of this, it’s possible that a voltage reading on the connection terminals

will be higher than the set value. The correct current can therefore only be measured

through the battery poles.

Soft start

The Promax 200 features a soft start, so that the charger has no influence on any power

users which may be turned on (such as lighting for example). Because of this the correct

charge level can only be indicated 3 min after start-up.

Temperature

The Promax 200 is protected against excess temperatures. At an internal temperature of

more than 40ºC the fan will turn on automatically. When the internal temperature is

cooled down until 35ºC, the fan also stops automatically. If the cooling of the fan isn’t

enough the charger will shut down totally. This thermal stop is indicated by an error

indication. When the charger has cooled down until 100ºC it will continue the charging

process. How the temperature protective devices operate will depend strongly on the

ambient temperature.

Level of protection

The indication for the degree of protection contains the character ‘IP’ (International

Protection) followed by two or three digits that stipulates the conditions that it complies

with. The first digit refers to the class of protection for density, the second digit to the

fluid density and the last digit refers to the impact resistance. The Promax 200 can be

assigned IP 205, which means:

2 = the charger is protected against solid particulate larger than 12mm.

0 = the charger is not protected against water/liquid etc.

5 = the charger can bear a n impact force of 2.00 Joule (2Nm) max.

Important

Protect the charger against moisture, pollution etc. This can be sucked in by the fan en

will damage the charger internally. The cost for this repair is not covered by warranty.

SETTING THE CHARGING PROGRAM

The charging program can be set by pressing the ‘mode’ pushbutton on the front of the

charger. Set the ProMax 200 to the correct program before mounting the case. The

battery may be connected already but this is not a requirement.

The set up of the charger consists out of three phases.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Proosten ProMax 200 - Software V1.3.1 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info