487941
3
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
Intended use
With the integrated heating module and the fan, the heater generates a warm air stream for
heating. Two heat output levels (750 or 1500 W) as well as a fan function without heating can
be selected with a rotating knob.
The product may only be used in dry, enclosed spaces.
Any use other than the one described above may damage the product. Moreover, this involves
hazards such as short circuit, re, electric shock, etc. It is not allowed to modify or rebuild any
part of the product!
Always observe the safety instructions included in these operating instructions. Please read the
operating instructions carefully and keep them.
This product complies with the applicable National and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Explanation of Symbols, Inscriptions
This symbol indicates a health hazard, e.g. electric shock.
ƽ
The exclamation mark indicates speci c risks associated with handling, function and
use.
The „Hand“ symbol indicates special tips and instructions.
Never cover the product, risk of re!
The product is only intended to be placed and used in dry and enclosed indoor
rooms; it must not get damp or wet.
The product complies with the protection class II.
Package Contents
• Heater
• Operating Instructions
Safety Instructions
ƽ
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any consequen-
tial damage!
Nor do we assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! The warranty
will be void in such cases!
a) In general
The unauthorised conversion and/or modi cation of the product is not permitted
because of safety and approval reasons (CE). Do not open/disassemble! Contains
no customer-serviceable parts.
Maintenance, adjustment or repair work may only be carried out by an expert/
authorised service centre which is familiar with the risks involved and the relevant
regulations.
The product is constructed according to protection class II.
The product is not a toy and must be kept out of the reach of children. Be spe-
cially careful if children are around. Children cannot see the danger arising from
incorrect use of electrical devices. Children might try to push objects through the
product openings, for example. There is a risk of a life-threatening electric shock!
Furthermore, there is a high risk of injuries from the hot surfaces!
Install the product so that it cannot be reached by children.
Do not carelessly leave the packaging material lying around since this may be-
come a dangerous toy for children.
Handle the product with care, it can be damaged by impacts, blows, or accidental
drops, even from a low height.
ƽ
b) Installation location
The product may only be used in dry, closed interiors, it must not get damp or wet!
Never set the product up in the direct vicinity of a bathroom, a shower or a bathing
tub or the like! There is a danger to life through an electric shock!
Never place the heater directly underneath a wall socket.
Choose an appropriate location. It must be sturdy, big enough, level, stable and far
away from in ammable materials and items (e.g. curtains, furniture, doors, etc.).
Maintain a minimum distance of 1.5 m.
The heater is only suitable for placement on a horizontal, level, even and suf-
ciently big surface (e.g, oor).
The product must not be exposed to extreme temperatures, direct sunlight or
strong vibrations.
Never place the heater on an unstable or movable surface. Always place the
heater in such a way that it cannot tilt or topple over.
A safety switch at the bottom of the heater automatically shuts off the heater when
it is lifted off the oor or tips over. Never block this safety switch!
Despite the safety switch there is a risk of re when the heater tips/falls over!
Furthermore, this could result in personal injury or damage to the product.
Due to the weight of the heater and the radiating hot air, the heater should never be
placed on valuable oor surfaces without adequate protection. This may not only
result in scratch marks or pressure marks, but also in discolorations due to the hot
air.
Never use the heater in vehicles and similar moving objects or spaces; it is only
suitable for use in buildings.
Unwind the mains cable completely during operation. The power cable must not
be pinched or damaged by contact with sharp edges. Do not place any objects on
the cable, and do not allow it to become kinked. Install the cable where no one
can stumble over it and the plug is easily accessible. Do not install the mains cable
under carpets or the like.
Do not operate the device in environments where there are high levels of dust,
ammable gases, vapours or solvents. There is a danger of re and explosion!
c) Handling and operation
Never plug in or unplug the plug-in power unit with damp or wet hands. There is a
risk of a life-threatening electric shock!
Never connect the device to the power supply immediately after it has been
brought from a cold room into a warm one. The condensation that develops in
such cases could damage the device or cause an electric shock! Allow the heater
to reach room temperature rst. Wait until the condensation has evaporated. This
might take several hours. Only after this the heater should be plugged into the
power supply and put into use.
Never operate the heater unsupervised.
Do not use the heater together with an additional timer, a remote switching device
(e.g. remote controlled socket) or similar devices, which automatically switch on
the heater. There may be a risk of re if the heater is covered or installed in the
wrong place.
Do not connect the heater to an extension cord or dimmer or the like. Directly plug
the power plug into a wall socket for example.
When using the heater for the rst time, hot parts of the case may cause an irritat-
ing odour for a while. If you experience this, ventilate the room where the heater is
set up.
Always pull the mains plug on the gripping surface intended for this purpose.
Never unplug the mains plug from the mains socket by pulling the cable!
Unwind the mains cable completely during operation. If the cable is not unwound
completely, it can cause overheating; danger of re!
Do not use the product when it is damaged (e.g. housing, mains cable). A defec-
tive connecting cable may only be replaced by a specialist. There is a risk of a
life-threatening electric shock!
Always pull the mains plug out of the mains socket before cleaning the heater, or
when the heater is not to be used for a while.
Always leave suf cient space from combustible or ammable materials or objects
(curtains, doors, furniture etc.). If the distance is too small, there is a risk of re.
Never operate the heater inside cabinets or other small enclosed spaces. Fire
hazard!
Never cover the heater, do not place clothing items or other objects on the heater.
Never block the air inlet/outlet! There is a danger of overheating and re!
OPERATING INSTRUCTIONS www.conrad.com
PTC Heater “Cube” 1500 W
Item no. 55 13 08
Version 09/11
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für PTC Cube wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info